Answered: Q9. If a 500 KVA, 200HZ transformer is…

Q9. If a 500 KVA, 200HZ transformer is operated at 50HZ, its KVA(s) rating will be- (a) 250 KVA (b) 125 KVA (c) 1000 KVA (d) 2000 KVA

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Question 2 A single phase 50 Hz core type transformer has rectangular cores 30 × 20 cm. and the…

A: The objective of the question is to find the number of turns per limb on the high and low voltage…

Q: A small filament transformer has a laminated sheet steel core whose average path length is 20cm and…

A: Given Average path lenght = 20 cm Cross sectional area = 5 cm2 Primary winding connection 120 V and…

Q: What's the maximum primary overcurrent device rating for a 0.50 kVA (500 VA), single-phase, 240V…

A: single phase transformer: S=VpIp500=240IpIp≅2.08 Ampere

Q: part d,e and f only

A: The circuit diagram is shown below,

Q: A 3-phase 100OKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102. The output…

Q: Explain the efficiency of increasing the electrical power system of connecting transformers in…

A: By connecting a number of transformers in parallel, greater load power can be supplied. Also,…

Q: $02 DEATH 3. Use the diagram below to answer the following questions: 10: 1 240v ✓ 50Hz Ver…

A: Use the given diagram below to answer the following questions, a) The transformer peak primary…

Q: A single-phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…

Q: The various types of errors in dynamometer wattmeters are A./Error due to Eddy currents B./Error…

A: The solution is given

Q: A 400/200 volts transformer has pu impedance of 0.05. The HV side voltage required to circulate full…

A: Turns ratio 400/200 i.e. Base voltage for HV, VHV(base)= 400 V Base voltage for LV, VLV(base) = 200…

Q: A (220/22) kV, 100 MVA transformer has x-0.5 pu, then its x in Q on the high voltage side is equal…

A: In this question we need to find a reactance on HV side of Transformer .

Q: A single-phase transformer has resistance and reactance of 0.2 pu and 0.6 pu respectively. Its pu…

Q: Air gap 0.001 m I = 4 A Area - 0.003 m² N = 100 turns lcan = 0.16 m Find the magnetic flux for the…

Q: A single-phase 764 V/ 1850 V, 54 Hz transformer has a maximum core flux density of 1 Tesla and an…

A: In this answer let us use the EMF equation of the transformer to find the number of primary turns as…

Q: Three Phase Transformer 3 Three Phase Transformer 4 Transformer 2 Transformer 4 Transformer 1…

A: Four circuit connections are given in the question.Note: For all the transformers the primary side…

Q: Please answer this diligently. Other answers in the internet seems wrong. Please help me understand…

Q: Refer to Figure I on Worksheet I, to answer numbers 18 through 27 based on the fact that it is a…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Why transformers are rated in kVA

A: Why transformers are rated in KVA ?

Q: 8A (L 2A

A: In source transformation, one source works at a time. When 8 A is OC , 9 ohm and 3 ohm resistors…

Q: a) The transformer has a turns ratio of 9.45, what is the dc load voltage without considering the…

A: Given Circuit: To determine: a) The transformer has a turns ratio of 9.45, what is the dc load…

Q: A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R…

A: In RL parallel connection branch resistor and inductor are connected in parallel with each other and…

Q: In short circuit of single phase transformer input power is equal to

A: Short circuit test usually conducted on H.V side and L.V side is short circuited.

Q: A 3-phase 10OOKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: In medium transformers, the total iron losses may vary from. rated output. % of the 0.4 to 1 O 0.2…

A: The iron loss of the transformer is defined as the sum of the hysteresis current loss, eddy current…

Q: A single-phase 685 V/ 1496 V, 55 Hz transformer has a maximum core flux density of 2 Tesla and an…

A: In this answer we will find the number of turns in the primary winding by using the emf equation as…

Q: Determine the peak-to-peak ripple and dc output voltages. The transformer has a 36 Vrms secondary…

A: Given, RMS voltage at the secondary side of the transformer, Vs=36 V Supply frequency, f=60 Hz…

Q: Write a conclusion to the different circuit.

A: Three different circuits are 1) Half wave rectifier 2) center tapped rectifier 3) bridge rectifier…

Q: 7. Two single-phase transformers, connected in open delta will supply power to a 200 hp, three-phase…

Q: In transformer, the hysteresis loss can be minimized by O using magnetic material with high…

A: For better understanding of the answer Let us first know what is Hysteresis loss Suppose if there…

Q: A 100VA single-phase transformer inside a refrigerator has 100 turns in its primary coil and 20…

Q: Two transformers are to be operated in parallel such that they share load in proportion to their KVA…

A: Given, Two transformers are to be operated in parallel such that Load ∝ kVA rating The rating of the…

Q: If a transformer is to be taken out for maintenance, as an engineer, outline the switching sequence…

A: Switching sequence – To turn on or off a bus bar, equipment, power plant requires expertise and…

Q: 8 The EMF induced in the secondary winding of a 50 Hz single-phase transformer having 500 turns on…

A: Given: The EMF induced in the secondary winding, E2=13.2 kV Frequency, f = 50 Hz Number of turns on…

Q: A single phase 50 Hz core type transformer has rectangular cores 30 x 20 cm. and the maximum…

Q: briefly explain what are the other typical applications can be used below mentioned T1.2…

A: In the given figure single phase isolation transformer is used for CNC machine protection

Q: A single phase 9.6 kVA, 500 V / 1.5 kV transformer has an impedance of 1.302 Ω with respect to…

A: GivenKVA of the transformer =9.6 KVA=0.0096 MVAPrimary side voltage=500 v=0.5 Kvsecondary side…

Question

Q9. If a 500 KVA, 200HZ transformer is operated at 50HZ, its KVA(s) rating will be-
(a) 250 KVA
(b) 125 KVA
(c) 1000 KVA
(d) 2000 KVA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Why there is humming soound in transformer?
The volts/turn of a 50Hz, 13800/460 V transformer is 6.68 Calculate the number of Primary and Secondary turns and the Flux in the core.
Two transformers are to be operated in parallel such that they share load in proportion to their KVA rating. The rating of the first transformer is 500 kVA and its pu leakage impedance is 0.05 pu. If the rating of second transformer is 250 kVA, then its pu leakage impedance is A 0.20 B 0.10 C 0.05 D 0.025
During faulty condition, high short circuit current in auto transformer is due to is higher
In the medium and large transformers, the total copper losses should be A2 % of the rated output. (a) 0.7 to 0.9 (b) 0.5 to 2 (c) 0.2 to 0.6 (d) 0.4 to 1 In DC machines, provides the magnetic path as well as the
c) A 100 kVA, 4500/250 V, 50 Hz single-phase transformer has 100 secondary turns.Determine: i.The primary current.ii.The secondary current.iii.The number of primary turns.
Give two reasons why transformers are an important part of the power distribution grid
A single-phase 730 V/ 1824 V, 56 Hz transformer has a maximum core flux density of 1 Tesla and an effective core cross- sectional area of 61 cm2 Determine the number of secondary turns. O 2137 O 1203 O 1203 O 48
26
SOLVE STEP BY STEP IN DIGITAL FORMAT
02. A certain transformer operating at a particular frequency has equal hysteresis and eddy current losses. If the voltage and frequency are doubled, the ratio of the hysteresis and eddy current losses is (a) 1:1 (c) 2:1 (b) 1 : 2 (d) 1:4
3. If the ratio of V/F has been kept constant and the observed value of hysteresis loss at rated frequency of 50 Hz is 18 W, the measured value of core losses is 35 W, Find the total core losses at the frequency of 60 Hz. 02: