Q70: For the truss shown in the Figure, if the diameter of pins at A and E are 60mm and 80mm, respectively. The stress in A is double shear while it is single shear in E. Determine the shear 3m 2m 2m 3 m 3 m G 3 m F 3m 110KN 110 KN stresses in pins at A and E and the stresses in members BG; and member BC if their diameter is 110 mm

Q: Rigid bar ABC is supported by a pin at bracket A and by tie rod (1). Tie rod (1) has a diameter of…

A:

Q: = A solid steel cylinder with diameter of 40 mm and a shear modulus of G = = 75 GPa has fixed ends.…

A: Step 1: Step 2: solution is given above Step 3: Step 4:

Q: The 40-mm diameter solid shaft ACBD is supported by two bearings at A and B. Due to the transmission…

A:

Q: A rigid plate (AC) is connected to flat steel bars by pins at A and B. The horizontal flat steel bar…

A: A rigid plate (AC) is connected to flat steel bars by pins at A and B. The horizontal flat steel bar…

Q: 4 ft Calculate the average shear stress in MPa of the pins B and C on the frame shown in the figure.…

A:

Q: A tent peg made from a circular steel rod is embedded in the ground as shown in the figure below.…

A: Given data: Overall length of the peg =150 mm=0.150 m embedded length of the peg L=117 mm=0.117 m…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.