Q7. A gear is lifted by a crane through a steel cable of length 4 m and diameter 0.01 m. If the natural time period of axial vibration of the gear isfound to be 0.1 s, find the mass of the gearwhen Young's Modulus of steel cable is 2.07*10¹1 N/m².

Q: cies of transverse ki and k2 at the P= 1000 N, p =

A:

Q: Q4. An air-conditioning chiller unit weighing 5.0kg is to be supported by four air springs. Design…

A:

Q: V3 F;(t) M3 k3 C3 V2 F;(1) m2 C2 Figure Q1

A: As per honor code and answering guidelines I can answer 1st three subparts at a time.If you want…

Q: and solve the frequency equation for transverse vit ition c cantilever beam carrying a mass m at its…

A:

Q: A mass of 40kg is attached to the free end of a iron cantilever beam of length 1000mm having a…

A:

Q: mass of 10 kN s²/m is suspended from a spring whose spring constant 40 kN/m. The mass is subjected…

A: Given system,

Q: A 160 pound object is suspended from a spring with spring coeficient 3 Ibt. The whole system is…

A: Given: F(t) = -32sin(2t)+21cos(2t) m= 160 lb k = 3 lb/ft c= 1 lb sec/ft

Q: 5. A weight of mass M = 8 kg is suspended by a spring with k = 10 N / m and c = 1.6 N s/m. The…

A: Given M=8kgK=10 N/mC=1.6 Ns/mThe governing equation of system isMx+Cx+kx=0˙¨

Q: The frequency of a damped harmonic oscillator is one-half the frequency of the same oscillator with…

A: Natural frequency: The number of vibrations executed by a body when it is vibrating freely in one…

Q: The static deflection of a spring under gravity, when a mass of 1 kg is suspended from it, is 3 mm.…

A:

Q: A steel bar of rectangular cross-section with 26 mm wide and 60 mm deep is freely supported at the…

A: Given: width of the section, w=26 mm or 0.026 m depth of the section, d=60 mm or 0.06 m mass, m=210…

Q: The free-fixed rod ( length of 2 m, diameter of 0.5 mm, density of 300 kg/m') vibrates in lengthwise…

A:

Q: Consider a mass m attached to a spring with natural length 7, hanging vertically under the action of…

A: the motion will be started from that instant when the system is released. ie. at t=0 But analysis of…

Q: A pulley weighing 500N is attached at the free end of a shaft which is fixed at the other end. The…

A: The schematic diagram of the given beam is Weight of the pulley at C, W = 500 N Diameter of shaft…

Q: k The 8.8 kg block is attached to a spring (k = 214 N/m) as shown. The small wheels serve to…

A:

Q: Find the period and make a graph of "x v/s t", of a mass-spring system with elastic constant K=8…

A: Givenk=8kg/s2m=2kgd=0.5m

Q: A four cylinders automobile engine is to be supported on three shock mounts as shown. The engine…

A: Given : m = 225 kg ζ=0.01 To find : Amplitude

Q: A disc shown at the picture below is mounted at the free end of a steel shaft 1.5 m in (7) length…

A: Given that, Torsional elastic modulus of the shaft, G=83×109 N/m2Length of steel shaft, L=1.5…

Q: To investigate the lateral motion of an engine attached to an aircraft wing in a gravitational…

A: The vibration during the occasional airplane is not usually happening. There are different factors…

Q: A box that contains of a 250 kg fragile instrument is transported by a truck that is subjected to a…

A:

Q: The phase angle describe the relative shift in the sinusoidal vibration of the spring mass system…

A: given; ϕ=phase anglex0=initial displacementx(t)=ω2x02+v02ω*sin(ωt+ϕ)and;ϕ=tan-1ωx0v0

Q: DETERMINE THE AMPLITUDE OF THE STEADY STATE VIBRATION AND ANGLE BY WHICH X LAGS Y.

A:

Q: A water tank weighing 68000kg is supported by four vertical pipe columns with fixed ends, as shown…

A:

Q: (5) A mass less flexible beam is hinged at one end and carries a mass m at the other end as shown in…

A:

Q: Determine flexural rigidity of the beam

A: Given; Consider a cantilever beam, having negligible mass and uniform flexural rigidity, length,l=…

Q: .X2 kl ww W1= 6KN W2= 8000N W1 ▶X1 k2 ml kl 12 KN/cm W2 k2 2 = 15KN/cm

A:

Q: A glider of mass 0.350 kg is placed on a frictionless, horizontal air track. One end of a horizontal…

A:

Q: A shaft 1.5 m long has a diameter of 5 cm for the first 75 cm and diameter 7.5 cm for the remaining…

A: The solution is in next step

Q: 500 mn 500 mm 150 mm

A: given data; ⇒lets take point C where spring is attached in rod.⇒mass of disc (m1)=3kg⇒mass of…

Q: personal frequency equation for the following

A:

Q: Compute the response of a spring mass system. A force of magnitude 25N, driving frequency of twice…

A: given:force of magnitude=25Ndriving frequency =2 X natural frequencyinitial…

Q: M3 C3 k2 C2 Figure Q1

A: As per honor code and answering guidelines I can answer 1st 3 sub part at a time if you want other…

Q: Find and solve the frequency equation for the transverse vibration of a cantilever beam carrying a…

A: The deflection of the beam due to the masses 2m and m is

Q: A vehicle of mass m = 500 kg travels over a long terrain that is approximately sinusoidal:y = d…

A: Given data as per questiona

Q: A spring-mass system kr, m has a natural frequency =f: (in Hz). If a second spring ka is added in…

A:

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.