Q6/ A signal having bandwidth equal to 3.5 KHz is sampled, quantized and coded by a PCM system. The coded signal is then transmitted over a transmission channel of supporting a transmission rate of 50 K bits/sec. Determine the maximum signal to noise ratio that can be obtained by this system. The input signal has peak to peak value of 4 volts and r.m.s. value of 0.2 volts. (ans. = 1966.08 = 33 dB)

Q6/ A signal having bandwidth equal to 3.5 KHz is sampled, quantized and coded by a PCM system. The coded signal is then transmitted over a transmission channel of supporting a transmission rate of 50 K bits/sec. Determine the maximum signal to noise ratio that can be obtained by this system. The input signal has peak to peak value of 4 volts and r.m.s. value of 0.2 volts. (ans. = 1966.08 = 33 dB)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Why is DC COUPLE recommended when measuring a low frequency signal?
Explain the difference between AC small signal amplifiers. from power amplifiers.
FM Demodulator Circuit Design I need an FM demodulator circuit for Frequency Modulated Sound Signal with 127MHz carrier frequency. I need clear mathematical steps for element value calculations. Thanks in advance.
3. The role of mixer in the Armstrong modulator is to. a) raise the carrier frequency b) lower the carrier frequency c) to change the carrier frequency to any required value For AMDSB-SC, The carrier is suppressed using a) A mixer b) A frequency multiplier c) A balance modulator 5. In FM modulation, frequency deviation is equal to .........., if the amplitude of the modulating signal is 4 V, and the frequency sensitivity of the modulator is 30 Hz/V. a) 120 Hz b) 34 Hz c) 100 Hz 6. A voltage controlled oscillator (VCO) is an oscillator that its frequency output is varied according to any change in the ............... at its input. 4. a) Frequency b) Current c) Voltage Q1: (B) Draw A block diagram to generate the SSB using Hilbert Transform method, Write an equation for an input, and output signals?
7-22 Abasehand signal with frequency components from near de to 15 kHz frequency modulates a 200-kHz carrier, and the frequency deviation is +3 kHz. The signal is applied as the input to a cascade of two frequency triplers and one frequency doubler. Determine the output (a) center fre- quency, (b) frequency deviation, and (c) deviation ratio.
Please answer question a and b
how can improve the spectrum O resolution?