Q5/A) From the figure below, determine the reaction force at pin C. A 000 -0.6 m 10 kN 0.6 m 0.8 m с 60° 0.4 m 6 kN B

Q: A force of 800 N is applied on a rigid bar as shown in the figure. The moment of F about origin O in…

A: Angle =60olength, L=4 m

Q: Suppose that F1 = 19 kN. a) Determine the x and y components of reaction at pin A using scalar…

A:

Q: Q-4. Determine the "Horizontal Displacement" of Joint "A' of the below given frame by using t…

A: Lengths of members, AB=BC=82+62=10 ft=120 in Also, AC=12 ft=144 in ∠BCA=∠BAC=tan-186=53.13°

Q: Given the Horizontal wood member shown that weights 38 lbs/ft and supports three vertical loads F1 =…

A:

Q: the magnitude of component parallel to the hinge axis of the door, (include units with answer) A:…

A:

Q: Question 2 Find the value of The reaction force at the support A. (X,XX,XXX represents the last…

A:

Q: 5. A person pulls on a rope with a force of 100 lbs as shown below. What is the moment about point A…

A:

Q: Draw the shear and bending moment diagrams for the horizontal boom of the crane as pictured here.…

A:

Q: Consider the frame shown in (figure 1). Suppose that w=460 N/m. Determine the x and y components of…

A:

Q: Example : The tension in the guy wire is 2500 N. Determine: a) components F, F, F of the force…

A: point of A and B  and the components of forces is given below…

Q: Problem 1: Replace the force system by a wrench. Also, find point P where the wrench intersects the…

A:

Q: Calculate forces (moments if applicable) for all points shown and write them down in a table.

A:

Q: Forces F1 and F2 act on the bracket as shown. Find R. F = 100 N 30 20 F2 = 80 N

A:

Q: Reactions at O: DO NOT FORGET UNITS AND FORCE & MOMENT DIRECTION! O = Compute the reactions at the…

A: for the given system  L = 6 m MB = 4 kN-m To determine  Reactions at support O

Q: Consider the bent bar ABC shown in the figure shown. It is supported by a roller at A and a pin at…

A:

Q: The A-frame is being hoisted into an upright position by the vertical force of 62 lb . (Figure 1)

A: Given data as per the question The magnitude of force F =62 lb finding the position vector along AC…

Q: *2-96. The tower is held in place by three cables. If the force of each cable acting on the tower is…

A: Givenx=20my=15m

Q: calculate the forces in AB and BC

A: The problem involves writing the forces in the members using Position Vectors and solving the…

Q: The spring AB has an unstretched length of 252 mm and stifness k=842 N/m. In the configuration…

A: Lo=252mm=0.252m K=842 N/m L=576mm=0.576m   To find: FBD

Q: a) Calculate the normal forces in points E and F which the brake blocks exert on the rim.

A: Given Data:  Applied tensile force on point H, T=160 N Sol: Consider the arm ADF  Freebody diagram…

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.