A force of 800 N is applied on a rigid bar as shown in the figure. The moment of F about origin O in clockwise direction is.FA4 m60°Select one:Oa. 732 N.mO b. 2771.3 N.mOc 3732 N.mO d. 1000 N.m

Answered: A force of 800 N is applied on a rigid…

A force of 800 N is applied on a rigid bar as shown in the figure. The moment of F about origin O in cockwise direction is 4 m 60°

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Find the moment with respect to point 'P' for the force system shown in the figure, where PQ = 5 m 5N -25 m.N O 25 Nm O -2.5 Nm O 2.5 Nm
The simply supported beam below has two different distributed loads acting on it. In the first section, the distributed load has a constant value of w = 13 kN/m. In the second section, the distributed load has a constant value of v = 8 kN/m. What is the total moment that these two loads create about point B in kN-m? W A 2m 1m V B
Find the moment (Nm) acting at O due to all forces and couple present in the following system if P = 310 N and Q = 998 N.
4.For the force system below find moment about point O. 30 45 F= 20KN 5m
What is the solution of this problem?
A simply supported beam is loaded as shown below. In the first region, the distributed load linearly increases from 0 kN/m to 15 kN/m. In the second region, the distributed load linearly decreases from 15 kN/m to 0 kN/m. What is the moment that this distributed load creates about point A in kN-m? W A 1m 1m 1m B
Find the moment of the Force P in the figure relative to the axis AD in terms of unit vectors.
Find the moment with respect to point 'P' for the force system shown in the figure, where PQ = 5 m P 5N -25 m.N -2.5 Nm 2.5 Nm 25 Nm
2) Reduce the forces acting on the beam in the figure to an equivalent singular force and couple at point A. Show the reduced force and moment by drawing the free body diagram of point A.
Suppose that over the next T = 30 seconds the driver can choose from the three possible force profiles, F(t), shown above, where P = 2000 N is the same maximum force reached during each profile. Write down an expression for each of the force profiles F1(t), F2(t), F3(t) as a function of the magnitude P and time. You can construct the force profiles from a combination of Heaviside functions and ramps (straight lines) with appropriate slope. Drag D 0 T/2 Case 1 U-HUT 3TAMATIU АЧАИ t $32 Speed v(t) P 10.100 t T/2 T T/2 Case 2 Case 3 T Force F(t)
A cable is attached at point B, as shown in the figure. The tension in the cable BC is equal to 800 lb. Find the moment about line AD created by the force exerted by the cable at point B. Z B 10 ft 5 ft A 4 ft C 2 ft D Drawing not to scale y X
2. In the design of an automotive control arm it is known that the spring force Fs=800N. Find the moment of this force about the bushing at A using vector cross products. MA= r x F FA 15° В 420 mm 170 mm E 190 mm 120 mm 180 mm