Q5/ A 6.6 kV/350 kV, 350 kVA, 50 Hz testing transformer when tested had the following observations: (a) No load voltage rise on HV side was 1% more than the rated value when 6.6 kV was applied on primary side. (b) The rated short circuit current was obtained on HV side when shorted with 8% rated voltage on primary side. Calculate (i) self-capacitance of transformer along with its HV side bushing, and (ii) leakage reactance neglecting resistance

Q5/ A 6.6 kV/350 kV, 350 kVA, 50 Hz testing transformer when tested had the following observations: (a) No load voltage rise on HV side was 1% more than the rated value when 6.6 kV was applied on primary side. (b) The rated short circuit current was obtained on HV side when shorted with 8% rated voltage on primary side. Calculate (i) self-capacitance of transformer along with its HV side bushing, and (ii) leakage reactance neglecting resistance

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Explain B-H Curve graph and how it works?
21 - The first Kirchhoff’s rule is related to ............ A) The sum of the currents at any junction ˃˃ 0 B) The sum of the currents at any junction = 0 C) The sum of the currents at any junction ˂˂ 0 D) The sum of the currents at any junction ≠ 0 E) The sum of the currents at any junction ≈ 0
1) a) Describe and compare Direct Current (DC) and Alternating Current (AC).
8. Determine the reluctance of a piece of cast steel of length 150 mm and cross-sectional area 1800 mm2 when the relative permeability is 4000. Find also the absolute permeability of the cast steel.
by High Voltage
1- spark gaps testing method is applicable for testing 2- the electrical circuit that we use to measure high voltages and is not affected by frequency change 3- We can say high voltages if exceed ------------ V (Alternating voltages) 4- Transient voltages which are caused over voltages be in two forms 5- High voltages can be generated for testing in three ways ------
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diodeshave? (Use constant voltage drop model for the Silicon diode) D IN4001 OV 10 kN IN4001 DELL