solve with use free body diagram, Please fast. Q(4) The engine block M with a mass of 250kg is suspended from the pulley system inFigure Q4. What force F must be applied to the end of the rope to keep the enginesuspended?FMFigure Q4A578 NBCDE591 N652 N788 N818 N

Answered: Q(4) The engine block M with a mass of…

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter7: Rotational Motion And The Law Of Gravity

Section: Chapter Questions

Problem 32P

See similar textbooks

Similar questions

A 0.400-kg pendulum bob passes through the lowest part of its path at a speed of 3.00 m/s. (a) What is the tension in the pendulum cable at this point if the pendulum is 80.0 cm long? (b) When the pendulum reaches its highest point, what angle does the cable make with the vertical? (c) What is the tension in the pendulum cable when the pendulum reaches its highest point?
To get in shape, you head to the local gym to exercise by lifting weights. Using a lat machine (Fig. P5.48), you notice that the wire connected to the bar is run around three different pulleys and is connected to a vertical stack of weights on the other end. The weights move up and down as you pull down on the bar. Suppose you set the machine so that the weight to be lifted is 120.0 lb. When you pull down on the bar, exerting a constant force, the acceleration experienced by the weights is 0.250 m/s2. What tension must exist in the wire connecting the bar and weights under these conditions? Assume the pulleys are massless and frictionless. FIGURE P5.48
A 0.500-kg potato is fired at an angle of 80.0 above the horizontal from a PVC pipe used as a “potato gun” and reaches a height of 110.0 m. (a) Neglecting air resistance, calculate the potato’s velocity when it leaves the gun. (b) The gun itself is a tube 0.430 m long. Calculate the average acceleration of the potato in the tube as it goes from zero to the velocity found in (a). (c) What is the average force on the potato in the gun? Express your answer in newtons and as a ratio to the weight of the potato.
What can you say about the velocity of a moving body that in dynamic equilibrium? Draw a sketch of such a body using clearly labeled arrows to represent all external forces on the body.
Lisa measured the coefficient of static friction between two pairs of running shoes and the track in Example 6.1 (page 159). If she wants to have an advantage in a race, which shoes should she wear, the ones with a high coefficient or the ones with the low coefficient of static friction? Explain.
The system shown in Figure P5.49 has an acceleration of magnitude 1.50 m/s2. Assume that the coefficient of kinetic friction between block and incline is the same for both inclines. Find (a) the coefficient of kinetic friction and (b) the tension in the string.
A child of mass m swings in a swing supported by two chains, each of length R. If the tension in each chain at the lowest point is T, find (a) the childs speed at the lowest point and (b) the force exerted by the seat on the child at the lowest point. (Ignore the mass of the seat.)
If you hold a horizontal metal bar several centimeters above the ground and move it through grass, each leaf of grass bends out of the way. If you increase the speed of the bar, each leaf of grass will bend more quickly. How then does a rotary power lawn mower manage to cut grass? How can it exert enough force on a leaf of grass to shear it off?
A filled treasure chest (m = 375 kg) with a long rope tied around its center lies in the middle of a room. Dirk wishes to drag the chest, but there is friction between the chest and the floor with s = 0.52. If the angle between the rope and the floor is 30.0, what is the magnitude of the tension required to just get the chest moving?
The drag coefficient C in FD=12CAv2 (Eq. 6.5) depends primarily on the shape of the object. You already have developed an intuition about what shapes correspond to a low C by observing the shapes of aerodynamic cars, boats, and even bullets. Which object, a sphere or a cube, would have a larger drag coefficient, assuming they are nearly the same size? Explain your reasoning. What aspect of an object most determines its drag coefficient?
(a) What is the maximum frictional force in the knee joint of a person who supports 66.0 kg of her mass on that knee? (b) During strenuous exercise, it is possible to exert forces to the joints that are easily 10 times greater than the weight being supported. What is the maximum force of friction under such conditions? The frictional forces in joints are relatively small in all circumstances except when the joints deteriorate, such as from injury or arthritis. Increased frictional forces can cause further damage and pam.
A uniform pole is propped between the floor and the ceiling of a room. The height of the room is 7.80 ft, and the coefficient of static friction between the pole and the ceiling is 0.576. The coefficient of static friction between the pole and the floor is greater than that between the pole and the ceiling. What is the length of the longest pole that can be propped between the floor and the ceiling?

SEE MORE QUESTIONS

Recommended textbooks for you

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Q(4) The engine block M with a mass of 250kg is suspended from the pulley system in Figure Q4. What force F must be applied to the end of the rope to keep the engine suspended? F M Figure Q4 A 578 N B C D E 591 N 652 N 788 N 818 N