Q4\ B\ calculate the resistance value required to connected with a moving coil voltmeter to produce one volt per division if the coil have 50 turns, with 4 cm long diameter and 3cm wide. The flux density of the magnetic field in the air-gap is 0.1 Wb/m.The control spring exerts a torque of 2.4x10 N-m when the deflection is 100 divisions on the full scale. Neglect the resistance of the voltmeter coil.

Q4\ B\ calculate the resistance value required to connected with a moving coil voltmeter to produce one volt per division if the coil have 50 turns, with 4 cm long diameter and 3cm wide. The flux density of the magnetic field in the air-gap is 0.1 Wb/m.The control spring exerts a torque of 2.4x10 N-m when the deflection is 100 divisions on the full scale. Neglect the resistance of the voltmeter coil.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Question Completion Status: Click Submit to complete this assessment. Question 8 What do you do to an asynchronous counter to let it count froms14 to 0? (Handwriting solution is needed: include this in your pdf file) Click Submit to complete this asseESment,
Please provide Handwritten answer. Electrical Engineering A 15 KHz tone is recorded at 8000 Hz. The frequency of the tone when played back at 8000 Hz is ____ KHz
Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…
Please, I need the final solution as soon as possible, I do not need any explanation or explanation
QUESTION 3 We are running 3 wires and a ground in a RMC to a control panel with a 60 amp circuit breaker disconnect in the control panel. The conduit is run along the ceiling where the ambient air temperature is 100 degrees. The control panel feeds our secondary cooling pump. What size are the ungrounded conductors? All conductors have typeTHHN insulation.
I have the answers fro my textbook they are not matching with the one that you send
Get the same shape required and Give proper label and title by using OCTAVE and write the program
i need the answer quickly
I want to solve both questions please
Grateful some help with this question thanks.