Q3. An insulating sphere of radius is concentric with an uncharged conducting hollow sphere, whose inner and outer radii are b and c. If the insulating sphere has a uniform charge density p and a total charge Q, (a) Find the magnitude of the electric field in the regions Insulator Conductor r< a, a c. (b) Determine the induced charge per unit area on the inner and outer surfaces of the hollow sphere.

Q3. An insulating sphere of radius is concentric with an uncharged conducting hollow sphere, whose inner and outer radii are b and c. If the insulating sphere has a uniform charge density p and a total charge Q, (a) Find the magnitude of the electric field in the regions Insulator Conductor r< a, a c. (b) Determine the induced charge per unit area on the inner and outer surfaces of the hollow sphere.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Determine the magnitude of the electric field at any point P a distance x from a very long line (a wire, say) of uniformly distributed charge. Assume x is much smaller than the length of the wire L, and let A be the charge per unit length (C/m). Z
You have built a device that measures the temperature outside and displays it on a dial as a measure of how far away from room temperature outside is. The way the dial works is that a needle with a charged ball on the end is placed between two charged parallel plates. The strength of the uniform electric field between the plates is proportional to the outside temperature. Given that the charged ball on the needle has a charge of −2.4 µC and the needle can be represented as a string with tension 0.350 N, and is at an angle of 22°, consider the following. What is the mass of the object? gWhat is the magnitude of the electric field? N/C
A parallel plate capacitor with a charge of +/-177nC has square plates length L=20.0cm across on each side. The plates are separated by a distance d=10.0cm. A positive +4.0microC point charge is held in place halfway between each plate on the right-most edge of the capacitor. While solving this problem ignore any distortion of the capacitor's electric field along its edges. A) What is the magnitude and direction of the capacitor's electric field at point P, which is midway between the plates and on the left-most edge of the capacitor B) What is the magnitude and direction of the electric field due to the +4.0 microC point charge at point P. C) What is the magnitude and direction of the net electric field at point P
a. A thin line charge, infinite in both directions, has a charge density per unit length of 2.00 µC/m. What is the electric field strength a distance 0.50 meters from the e. (axioc) 3.8 X104 RTT( 8.85x1018) cokec tion: ヤート D. A -5.00 µC charge is 0.50 meters from the line charge mentioned in part a. What is the electrostatic force on this charge? Is this force directed toward or away from the line charge? Fこ EG -(3.8x104) (-5x16-6) - 0.19 remains can- the kin anetic A large flat insulating membrane has a uniform chargeo of +12.0 µC/m². What is the electric field strength above the charged surface? с. (こマメIC6 つ1Xと =2 2(8.85x1019) 5.31 X107 w ould double Cth d. Suppose a +4.00 µC charge and a +7.00 µC charge are separated by 3.00 meters. How far from the +4.00 µC charge does the electric field vanish? What the the magnitude of the force on a test charge is it is placed at this point? Enew, 72F ベ-8 (7x100) RF F=(4X10
B2
QUESTION FIVE A. Copperbelt Energy Corporation (CEC) intends to lay an infinitely long conductor with charge density and length L, on one of their project sites on the Copperbelt. As a Graduate Engineer working for Copperbelt Energy Corporation (CEC), you have been assigned to be the lead project Engineer You supervisor has tasked to apply Gauss law principles that you learned during your undergraduate studies to determine the electric field a point P, which is located at a distance r meters the from the conductor. Assuming a cylindrical Gaussian surface due to the symmetry of wire, clearly show how you would go about in executing this task.
A uniform electric field of magnitude E = 36 N/C points along the x-axis. A circular loop of radius R = 21 cm is centered at the origin with the normal to the loop pointing θ = 35 degrees above the x-axis. a.) Calculate the electric flux in units of N⋅m2/C that passes through the loop. b.) To what angle in degrees relative to the x-axis should the normal of the loop be rotated so that the flux through the loop becomes Φ' = 0.41 N⋅m2/C?
A uniform electric field of magnitude 45.1N/C is parallel to the x axis. A circular loop of radius 29.7cm is centered at the origin with the normal to the loop pointing 64.9∘ above the x axis. a. To what angle, in degrees from the positive x axis, should the normal of the loop be rotated so that the flux through the loop becomes 0.434N⋅m2/C?
A uniform electric field of magnitude 43.1N/C is parallel to the x axis. A circular loop of radius 25.7cm is centered at the origin with the normal to the loop pointing 27.4 above the x axis. A). Calculate the electric flux in, newton squared meters per coulomb, through the loop. B). To what angle, in degrees from the positive x axis, should the normal of the loop be rotated so that the flux through the loop becomes 0.419N⋅m2/C?
RC-1 A charge +Q is evenly distributed around a semicircle of radius R in the x-y plane as shown to the right. a) Use dq charge elements to explain why the net field at the center of the semicircle (the origin) has no y component. Use a drawing like the one shown in your explanation. b) Apply Coulomb's law to calculate the strength (magnitude) of the net electric field at the origin in terms of K, Q, R and any other constants needed. R X
A laboratory has a region with a constant E = 1000N / C electric field in the vertical direction. A proton is thrown into this region at h = 1 m above the ground and with a horizontal velocity Vo = 106 m / s.a. What is the acceleration of the proton in the electric field region?b. What is the horizontal range (L) of the proton?c.How long does the proton cross the electric fieldThe mass of the proton is mp = 1.7x10-27kg, and its charge is qp = 1.6x10-19C.Neglect the force of gravity.
4. A cylindrical dielectric of permittivity &, radius R, and length h, is centered about the z-axis. Assume this Cylinder has a uniform electric polarization along its axis given by P = Poz. a) What are the polarization charge densities on its surfaces? b) What is the electric displacement vector D anywhere on its axis? c) What is the electric field vector E anywhere on its axis?