Q3/ The following consecutive readings were taken with a leveling instrument at intervals of 20m 2.375- 1.730-0.615-3.45-2.865-2.070-1.835-0.985-0.435-1.630-2.255 and 3.630 m the instrument was shifted after four and eighth reading. thc reading was taken on B.M. of R.L. 114.380 m on station three find the R.L. all the point using High of insturemt calculate,

Q: Q1 (a) Q1(b) RL TBM A RL TBM B RL TBM A RL TBM B AAA.AAA ВBB.BB AAA.AAA ВВB.ВB 135.975 134.665…

A: a. Rise and Fall method: Arithmetic check:…

Q: Q4: a. The following readings were observed successfully with a leveling instrument. The instrument…

A:

Q: (c) A Dumpy Level was place at the mid point C of A and B which were 200 ft apart. The staff…

A:

Q: A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ftft) and closed on…

A: BM Hydrant = 5869.31 ft BM Rock = 5830.03 ft

Q: Q2) 1-Four stations C, A, B, and D were set out in a straight line such that CA = AB= BD = 30 m. A…

A: Given: CA = AB = BD = 30m level at C A1=2.135, B1= 1.823 level at D A2= 2.026, B2= 1.768 Required:…

Q: 10. Complete the following table using the knowledge obtained in class about differential leveling…

A: Given Data Total 5 stations has been given and we are asked to calculate the Elevations, adjusted…

Q: Leveling Rod Leveling Rod BS L₂ BS TP BM, Elev. of TP, Difference in Elev. between and BM₂ BM Elev…

A:

Q: The following readings were taken B33 operation from points 1 to 12, (2.08, 1.625, 3.2, (1.67 and…

A:

Q: The following staff readings were observed successively with a level. The instrument has been…

A: The objective of the question is to calculate the Reduced Level (RL) of all points using the plane…

Q: The upper and lower stadia hair readings on a stadia rod held at station B were observed as 3.50 and…

A: Given:- The upper and lower stadia hair readings on a stadia rod held at station B = 3.50 m and 1.00…

Q: A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ft) and closed on BM…

A: BM Hydrant BM Rock Readings (in feet) given in the order taken are, 2.68 (+S) on BM Hydrant, 5.59…

Q: A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ft) and closed on BM…

A: BM Hydrant =5869.31 ftBM Rock (orthometric height 5830.03 ft). Readings  2.28 (+S) on BM Hydrant,…

Q: The following consecutive readings were taken with a leveling instrument at intervals of 25 m.…

A: There are two methods of solving this problem. 1.Height of instrument method (HI method) 2.…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.