Q3: An overhead transmission line conductor at river having two un same level towers, the height of towers of 45 m, 80 m respectively and 'o' point out towers. If the maximum un vertical sag is 40 m and the tension in wires is 3000 N/cm2, the wind pressure is 100N/m .If the weight of one meter of conductor is 8 N and cross sectional area is 8cm2 .Find the spam between towers.

Q3: An overhead transmission line conductor at river having two un same level towers, the height of towers of 45 m, 80 m respectively and 'o' point out towers. If the maximum un vertical sag is 40 m and the tension in wires is 3000 N/cm2, the wind pressure is 100N/m .If the weight of one meter of conductor is 8 N and cross sectional area is 8cm2 .Find the spam between towers.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Three conductors of a 3-phase overhead line are arranged in a horizontal plane in the order a-b-c, distance between a and b is 12 m, b and c is spaced 12 m apart. The diameter of each line conductor is 2 cm. Calculate the Capacitance per phase per km (C1) for this arrangement. Calculate Capacitance per phase per km(C2) if the spacing between the conductors are reduced by 1/4th of the given spacing. Capacitance in per Phase per Km for Arrangement 1 (C1) Capacitance in per phase per km for Arrangement 2 (C2)
4. A 4160V, three phase source, 4-wire supplying an unbalanced three phase load. The unbalanced connected load are: Zan = 150/53.13° ; Zbn = 150-53.13° ; Zen = 1500° Assuming positive sequence and the reference is the line voltage "a", determine: a. the line current "a" b. the line current “b” c. the line current "c". d. the total real power e. the total reactive power f. the total apparent power g. the overall power factor. h. the neutral current.
For the Figure 9 shown: A 65 -km long, 59 Hz, three-phase, transmission line is composed 2 parallel lines. The conductors in the lines are stranded with GMR of 15.92 -mm each. If the distance D in the figure is 2.46 m., What is inductive reactance per line in (ohm)? Figure 9 $0 D 1.732D 2D 1.732D 1.732D D b' 1.732D
Q2(a) Figure Q2(a) shows the spacing of a double circuit 3-phase overhead line. The phase sequence is UVW and the line is completely transposed. i) Critically assess the advantages of double circuit line over single circuit line Calculate the inductance per phase for 500 meter length of line using Table 2(a) data for the Figure Q2(a). Table 2(a) GMR of the line 0.01m Distance a-b' 6.m Distance c-c' 8.3m a b Figure Q2(a)
In an overhead transmission line, if 'L' is the length of span in meters, 'w' is the weight of conductor per meter, and 'T' is the allowable tension in the conductor in kg, then the sag 'S; in meters is given as (a) wL²/8T (c) WL³/8T (b) WL²/4T (d) WL4/8T
Question 3. A three-phase impedance load balanced D a connected load in parallel with a balanced ? connected load made of bonding. D each arm for the load ?D = 6 + 6? and ? each arm for the connected load It is given as ?? = 2 + 2?. ? the connected load ?? = 1? is earthed through the neutral impedance. To this impedance load, the symmetrical component voltages ?0 = 10∠60°, ?1 = 100∠0° and ?2 = Unbalanced phase-to-earth voltages ??, ?? and ?? of 15∠200° volts were applied. a) Draw the zero, positive and negative sequence circuits. b) Find the complex powers imparted to each component circuit.
Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides 20, 10, and 18 meters. The diameter of each line conductor is 1 cm. Calculate the Capacitance per phase per km (C1) for this arrangement. Calculate Capacitance per phase per km(C2) if the spacing between the conductors are reduced by 1/4th of given spacing. NOTE -- an Capacitance inuF per Phase per Km for Arrangement 1 (C1) Capacitance in µF per phase per km for Arrangement 2 (C2)
A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of D-14 meters, as shown in the below figure. The conductors have a diameter of 2.6 cm and a GMR of 1.012 cm. Find the capacitance per phase per kilometer of the line a D D 2D Select one: a 0.0088 microF/Km Ob. 0.0077 microF/Km Oc1455 microF/Km Od. None of these
None