Q3) An instrumentation amplifier is used to amplify a small signal from differential pressure sensor that its maximum output is equal to 16 mV. The signal is connected to an instrumentation amplifier before interfacing it with 24 V analog to digital converter. Design a suitable instrumentation amplifier circuit to amplify the sensor's signal that allows using the full span of the ADC.

Q3) An instrumentation amplifier is used to amplify a small signal from differential pressure sensor that its maximum output is equal to 16 mV. The signal is connected to an instrumentation amplifier before interfacing it with 24 V analog to digital converter. Design a suitable instrumentation amplifier circuit to amplify the sensor's signal that allows using the full span of the ADC.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3. Discuss the main reason for the probable error occurred during experiment 4. The condition needed for feedback oscillator to start oscillation is: 5. A square wave signal can be obtained by 6. A triangle wave signal can be obtained by... 7. A sine wave signal can be obtained by ... 8. Determine the information you get from each figure.
(a) ii please in photo
Explain the operation of a 3-bit counter type Analog to Digital Converter with an example for 2.3 V analog input voltage and 1 V resolution.
TRUE OR FALSE Increasing R2 increases the single-ended and double-ended differential mode gains of the differentialamplifier. Increasing R2 decreases the transistor DC currents and decreases the DC output voltages.
b. A 6.1-V analog input voltage is to be converted to digital using 4-bit DAC a successive approximation register (SAR) ADC whose block diagram is shown in Figure 2. Describe the conversion process by re-drawing Figure 2 at each conversion step and explain the operation of the ADC briefly. (30 Points) 6.1 V SAR MSB Figure 2. A SAR ADC block diagram.
DRAW CIRCUIT OF ANALOG TO DIGITAL CONVERTER CIRCUIT. AND EXPLAIN HOW IT WORKS
A pulse width modulated output is configured with an 40MHz clock, a prescaler of 80 and a count register of 1000. What is the frequency of the PWM signal?
Answer the following questions about Digital to Analog Converter (DAC): 1. Write its definition. 2. Draw its block diagram.
Consider two amplififiers with the following parameters: Amplififier A: Gain = 20 dB; Noise ratio, NR = 1.05 Amplififier B: Gain = 20 dB; Noise ratio, NR = 4.1 Identify the amplififier that adds the least internal noise to the input signal and determine its noise fifigure in dB.
What is sample and hold circuits?
In an R-2R type DAC circuit taken as logic 1 = 3 volts and logic () = 0 volts, if the output voltage is measured as l Vo l = 3.75 volts, design it by calculating the input logic value.
1. For the pointer position in the diagram, what is the input signal if the range is set at 0.3 V? A. For the pointer position in the diagram, what is the input signal if the range is set at 1 V? B. For the pointer position in the diagram, what is the input signal if the range is set at 30 V? C. Let’s say you know that the input signal will be about -0.25 V. What range should you select to give maximum deflection without going off scale? Draw a line, with a straight-edge, on the picture above, showing how the pointer would point.