Q3/ A 600-kg car is moving on a level road at 30 m/s. (a) How large a retarding force (assumed constant) is required to stop it in a distance of 70 rn? (D)friction between tires and roadway if this is to be possible? Assume the wheels are not locked, in which case we are dealing with static * .friction * there's no sliding

Q3/ A 600-kg car is moving on a level road at 30 m/s. (a) How large a retarding force (assumed constant) is required to stop it in a distance of 70 rn? (D)friction between tires and roadway if this is to be possible? Assume the wheels are not locked, in which case we are dealing with static * .friction * there's no sliding

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

O-A vehicle is moving on a road of grade +4% at a speed of 20 m/s. Consider the coefficient of rolling friction as 0.46 and acceleration due to gravity as 10 m/s2. On applying brakes to reach a speed of 10 m/s, Find the required braking distance (in m, round off to nearest integer) along the horizontal.
3. The front wheels of an experimental rear-drive vehicle have a radius of 300 mm and are designed with disk-type brakes consisting of a ring A with the outside and inside radii of 150 mm and 75 mm respectively. The ring, which does not turn with the wheel, is forced against the wheel disk with the force of P. If the pressure between the ring and the wheel disk is uniform over the mating surfaces (new surface), compute the friction force F between each front tire and the horizontal road for an axial force P = 1 kN when the vehicle is powered at constant speed with the wheels turning. The coefficient of friction between the disk and the ring is 0.35. Ans: F = 136.1 N 150 mm 75 mm 300 mm P P
X
Determine the horizontal force required to move a 2500-lb automobile with 23-in.-diameter tires along a horizontal road at a constant speed. Neglect all forms of friction except rolling resistance, and assume the coefficient of rolling resistance to be 0.05 in.
In a very foggy day, the road visibility is no more than 30m ahead.Given that the coefficients of static and kinetic friction between thetyres and the road surface are 0.9 and 0.8 respectively. (a) If the driver can act immediately when he sees obstacle ahead,i.e. reaction time is zero, find the maximum speed limit.(b) If the driver has reaction time of 0.3 second, what will be thenew maximum speed limit?
A 1000kg car rounds a curve on a flat road of radius 50m at a speed of 50kph. Compute the maximum coefficient of friction must the pavement have to prevent the car from sliding?
The coefficients of friction between the load and the flat-bed trailer shown are 0.35 (static) and 0.30 (kinetic). Knowing that the speed of the rig is 72 km/h , determine the shortest distance in meter in which the rig can be brought to a stop if the load is not to shift.
If the distance between the tires is 2.6 m and the center of mass of the car is located 1 m above a horizontal ground. Determine the maximum constant speed that the car can travel without overturning. 90 kph а. 140 kph 180 kph d. 200 kph b. C. е. none of the above
The 1540-kg car has a velocity of 26 km/h up the 10-percent grade when the driver applies more power for 18 s to bring the car up to a speed of 67 km/h. Calculate the time average F of the total force tangent to the road exerted on the tires during the 18 s. Treat the car as a particle and neglect air resistance. | 10 100 Answer: F = i kN
A 2500-lb passenger vehicle originally traveling on a straight and level road gets onto a section of the road with a horizontal curve of radius = 850 ft. If the vehicle was originally traveling at 55 mi/h, determine (a) the additional horsepower on the curve the vehicle must produce to maintain the original speed, (b) the total resistance force on the vehicle as it traverses the horizontal curve, and (c) the total horsepower. Assume that the vehicle is traveling at sea level and has a front cross-sectional area of 30 ft2. Show your solutions and answers.
Note:hand written solution should be avoided.
A car has a wheelbase of 250cm and a center of gravity that is 100cm behind thefront axle at a height of 60cm. If the car is traveling at 130 kph on a road with poor pavement thatis wet (μ = 0.6), determine the percentage of braking forces that should be allocated to the frontand rear brakes (by the vehicle’s braking system) to ensure that maximum braking forces aredeveloped.