Q2:A uniform live load of 10kN/m and a single live concentrated force of 30 kN are placed on the top beams shown in figure(2). If the beams also support a uniform dead load of 4kN/m, determine (a) the maximum positive shear in midspan panel (BC) of the girder, (b) live load maximum positive moment in the girder at (C).(c)maximum reaction at support(B). Assume support at B is a roller and support at D is a pin. AI Ic B

Q: Q-2 The continuous beam ABC is hinged at A with roller supports at B and C. It is loaded with a…

A: A beam is given we need to find out  1.Support reactions 2.Draw shear force and bending moment…

Q: Q2: A uniform live load of 2.8 kN/m and a single concentrated live force of 20 kN are placed on the…

A:

Q: O kN are placed on the floor beams. If the beams also sup ad of 700 Nm, determine (a) the maximum…

A:

Q: 550 Ibf 480 lbf 58°, 75 Ibf/ft A 4 ft 3 ft 3 ft 10 ft 400 Ibf/ft For the cladding support frame,…

A:

Q: A portal frame has internal hinge in span BC as shown in figure. A point load traverses from B to C.…

A: A portal frame has internal hinge in span BC as shown in figure.A point load traverses from B to…

Q: The beam shown below supports several loads. The beam pin support at A, and two roller supports at B…

A:

Q: B 80 cm 3 kN/m -3m-4m 2m D Determine the following: 120 cm 200 cm a. Vertical reaction at point A.…

A: As per guidelines, first three sub parts have been solved.

Q: determine the reactions at supports A, and C? 3 m 3 m 20 kN G F E 80 kN 20 kN 4 m 40 kN A B C D 4 m…

A:

Q: 10 ft 12 ft D E 60 k Pins at B and D 16 ft Fixed at A Pinned at F F - 8 ft A Prob 5) Solve for the…

A:

Q: For the frame shown, determine the reactions at the supports (support A is a hinged while B is a…

A:

Q: The ramp of a ship has a weight of 200 lb and a center of mass at G. The ramp is attached to the…

A: The given figure is shown below:

Q: Q2 The truss shown in Figure 2 is supported by a pin and a roller at joints A and E respectively.…

A: The load acting are 100 KN at C200 KN at D 300 KN at H Support A is Hinged support and support E is…

Q: 1. Determine the reactions at the supports for the beam shown. а). 6 KN/m 3 KN/ 2 KN/m B 3 т 9 m 6 m…

A:

Q: Determine the reactions at supports A, B, C using Force method

A: The given beam is indeterminate beam.The given beam can be solved by force method.The theorem of…

Q: 1.2-14 A plane frame is restrained at joints A and D, as shown in the figure. Members AB and BCD are…

A:

Q: 1. The truss is supported by a hinge at A and a roller at Bas shown. Find the reactions in the…

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.