Q2/A Four- pole generator having Waver Wond armaturewinding has 5l slots, each elot containingwhat will be the Voltage generat eel in fhe machine Whendriven at 1500 rpm assuming thc flux por pole to20 Conductors.be 70m Wb ?

Generated emf =)(flux×speed×no. of armature conductors)/60)×(Poles/parallel paths).

Q2/A Four pole generator havi ng Waver Wond armature winding has 5I slots, each slof contnining what will be the voltage yenerat eel in fhe machine When driven at Is00 rpm assuminy the flux por pole to 20 Conductors . be 70 m Wb?

Q2/A Four pole generator havi ng Waver Wond armature winding has 5I slots, each slof contnining what will be the voltage yenerat eel in fhe machine When driven at Is00 rpm assuminy the flux por pole to 20 Conductors . be 70 m Wb?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Flashing the field of a direct current generator implies Neutralising residual magnetism…

A: Flashing the field of a direct current generator implies that

Q: A 6 pole, DC generator has a wave-wound armature containing 30 coils of 5 turns each. Its flux per…

A: Given- Number of poles P=6, DC generator- wave-wound armature, 30 coils of 5 turns each, Number of…

Q: 4. A three-phase A-connected six-pole winding is installed in 36 slots on a stator. There are 150…

A: Introduction A three-phase delta-connected system is a type of electrical power distribution…

Q: What are the rotating parts on d.c machine. * brushes inter-pole commutator segments O pole shoe

A: In dc machine field winding is statinary and armature winding is rotating.

Q: An 8 pole, simplex wave, series generator is wound for 130V, 500 A capacity. It has an armature…

Q: a)find the flux density in airgap. b)if the stator is excited with 50 Hz current, find the…

A: Given: A 2 pole synchronous machine in which lg=2.5mmAg=500cm2I=5AN=500μc=∞ According to question:…

Q: A 6 pole DC wave wound generator has 21 armature conductors with flux per pole is 29 mWb and the…

A: emf indued E = Flux×speed×no.of conductors60×no. of polesno. of parallel paths Given Flux=29 m Wb…

Q: Q3/ A 4.pole generator huving wave wound armture Winding what Bill be voltage gunaratal at lo00 rpm…

A: GivenNumber of poles P=4Wave wound⇒Number of parallel paths=A=2Nuber of slots=60Number of…

Q: ih 16 A 2-pole d.c. shunt generator has a useful flux per pole of 0.03 Wb. The armature winding…

Q: A 4 pole generator with wave wound armature has 54 slots each having 26 conductors. The flux per…

Q: A distance relay is capable of measuring the from the relay location up to certain distance is…

A: As per Bartleby guidelines we are supposed to solve only one question, please ask the rest again.

Q: fill inthe blank : field winding has large numberofturns of thin copper wire. a.…

A: Correct option is Shunt. shunt field winding has large number of turns of thin copper wire. Where…

Q: A 2-pole d.c. shunt generator has a useful flux per pole of 0.03 Wb. The armature winding consist of…

Q: Mechanical losses represent: A. Windage losses B. None of the other choices are correct O C. Losses…

A: In this answer let us try to understand what are mechanical losses as explained below.

Q: the armature mmf can be -2 reduced by reluctance of the magnetic the circuit in the region of the…

A: The explanation is as follows.

Q: 4- In DC Shunt genrator, the effect of flux Produced by armater on main Flux Produced by the field…

Q: The hysteresis loop occurs because: Select one: a. The machine is full-loaded b. some eddy current…

A: consider the given circuit;

Q: PZ 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is…

Q: In a certain magnetic circuit, the core is represented two reluctances as shown below. Assume a…

A: The magnetic circuit diagram is shown below, Number of turns, N=640 turns.Current, I=2.2 A.

Q: Maximum torque is realized when an armature winding is with the magnetic field at 90° O inline or at…

A: With reference to synchronous machines, the load angle or the power angle is the angle between the…

Q: A four-pole dc generator has a wave-wound armature containing 48 slots with eight conductors per…

Q: 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is 60…

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

A: In this question, DC Generator , Number of pole P= 8, Number of conductors Z= 240 Flux = 0.04wb…

Q: Calculate the phase and line voltages of three phase star-connected 4 pole small alternator having a…

A: Given data, The total flux is 0.30 Wb. The relative speed is 1500 rpm The number of pole is 4. The…

Q: electromotive force created by a direct current generator is proportional to Flux/pole…

A: We need to tell about generated emf . We know direct formula for emf .

Q: A four pole, 1200 rpm DC lap wound generator has 1520 conductors. If the flux per poles is 0.01 Wb.…

A: Given: DC lap wound generator having P=4N=1200Z=1520ϕ=0.01 Wb

Q: Differentiate the two generators shown in Figure 1.6.1-1 and Figure 1.6.1-2. The output voltage can…

A: Consider the first generator: This is a permanent magnet generator that is a machine that changes…

Q: (d) Compute the current from a to b through a 40 “load" resistor connected to the terminals. (e)…

Q: 57. One of those listed is not a type of de generator winding A drum D. lap B progressive C. gramme…

A: 1) The correct answer is magnetic starter. Explanation: It is a device originated to supply power…

Q: A 6 pole DC wave wound generator has 41 armature conductors with flux per pole is 26 mWb and the…

A: Find the speed of the dc machine if the all parameters are given.

Q: The bearings and commutator rotation of the DC machines which causes the O Hysteresis loss O Ohmic…

Q: A 6 pole DC wave wound generator has 30 armature conductors with flux per pole is 25 mWb and the…

Q: justify the following statement: if the interpole winding is left unexcited, commutation will be…

A: Ans . NO

Concept explainers

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.

Question

Q2/A Four- pole generator having Waver Wond armature
winding has 5l slots, each elot containing
what will be the Voltage generat eel in fhe machine When
driven at 1500 rpm assuming thc flux por pole to
20 Conductors.
be 70m Wb ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Winding and Construction of the Rotor and Stator

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Stray losses represent: O A. Resistive losses in the windings of the machine O B. Losses due to friction of the moving parts O C. Losses due to magnetization and demagnetization of the core O D. Windage losses O E. None of the other choices are correct
Q2. A 4-pole, wave-wound armature has 72 slots with two coil-sides per slot, each coil has four turns. If the flux per pole is 20 mWb and the armature rotates at 720 rpm, what is the induced emf across the armature? (Ans. 276.48 V) 0.05
please help
Explain the principles of starting a slotted pole by drawing a phase diagram of fluxes
A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive force generated in each case if you know that the number of conductors in the armature slots is 240 . The magnetic flux of each pole 0.04 Wb. It runs at 1200 rpm
A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive force generated in each case if you know that the number of conductors in the armature slots is 240 . The magnetic flux of each pole 0.04 Wb. It runs at 1200 rpm
Is this armature winding a progressive or a retro-progressive winding? W N Select one: 2 B 4' O a. Both O b. Progressive OC. Neither O d. Retro-progressive B S
A wave wound DC generator has 6 poles and the armature has 756 conductors. How fast should the armature rotate if the flux is 20 mWb per pole and 240 V is desired?
A dc machine has 4-pole, wave wound armature with 46 slots and 16 conductors per slot. If induced voltage in the armature is 480 V at 1,200 rpm, determine the flux per pole
A 60 Kw, 4 pole generator has a lap winding place in 48 armature slot contains 6 conductors, the pole flux is 0.08 wb and the speed is 1040 RPM, what is the generated voltage
Q2. A 4-pole, wave-wound armature has 72 slots with two coil-sides per slot, each coil has four turns. If the flux per pole is 20 mWb and the armature rotates at 720 rpm, what is the induced emf across the armature? (Ans. 276.48 V) 03 A 4 nolo nmeghine he umoture vith 00 clots ond o gonduetors nor elet the fluy nor nole is 005