Answered: Q2. For a specific spring where the…

Q2. For a specific spring where the load applied is 100 N, coil diameter is 4 mm, spring diameter is 20 mm. Calculate the point where the total shear stress induced in the spring is equal to zero.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

(8) The smaller of two concentric spring is made of 22mm diameter steel & has an outside diameter of 100mm with 10 active coils. The outer spring is made of 32mm steel spring & has an outside diameter 250mm with 8 active coils. Before the load is applied, the outer spring is 25mm longer than the inner spring. If the load of 90kN is applied to this nest of springs, (a) find the spring rate of each spring; (b) what portion of the total load is carried by each spring? Use G = 80GPa
Don't give handwritten
Solve Exercise 4 showing detailly all the steps with including all explanations
Suppose you have three springs with force constants of K₁ = K₂ = K3 = 3.30 × 10³ N/m. What is their effective force constant if one is hung from the other in series? You may assume the springs have negligible mass. N/m
Problem 7. We have a line of two equal masses m connected by three springs with spring constants c₁ = 1, c₂ = 1, and c3 = S. Spring 1 is fixed at the top and spring 3 at the bottom, so xo = x3 = 0. (a) Find the stiffness matrix K in the equation Kx = f for the mass displacements. (b) Solve for the displacements x₁ and x2. (c) If the third spring constant S becomes very large or very small (S→∞ and S→ 0) what are the limiting values of the displacements x₁ and .x₂? (d) If the third spring constant S becomes very large or very small (S→∞ and S→ 0) what are the limiting values of the spring forces y1, y2, and y3? 91 www m 3-WW www C₁ X₁ "Xo = 0 C2₂ X2 C3 X3 = 0
Q2 / A belt drive consist of two V-belts in parallei, on grooved pulleys of the same size. The angle of the groove is 30". The cross - section area of each belt is 750 mm? and u is 0.12. The density of the belt material is 1.2 Mg/m' and the maximum safe stress in the material is 7 MN/m. Answer the following questions 1- The centrifugal tension in belts is . . (a) increases power transmitted (b) decreases power transmitted (e) have no effect on power transmitted (d) increases power transmitted up to a certain speed and then decreases
i.Considering the rod diagrammed below; calculate an equivalent spring constant or the rod using the length of the rod 1, its area A, and Young's nodulus E for a compressive force F that compresses the rod a distance x. Additionally, is a linear spring a useful model for a rod under compression? What if the rod is under tension? compressed rod
I need handwritten solution only otherwise skip note that
Q2: Consider the steel spring in the illustration. (a) Find the pitch, solid height, and number of active turns. (b) Find the spring rate. Assume the material is A228 music wire. (e) Find the force F, required to close the spring solid. (d) Find the shear stress in the spring due to the force F, 120 mm M W 3.4 mm 50 mm
4
4. Solve for the tension in the cable. p=0.20 300 lb 200 Ib
Subject: Statics of Rigid bodiesshow your solutions