Q2). Calculate volume of cut and fill, the elevation of natural ground shown on all nodes and design elevation is equal to 103 m, all dimension and elevations are in meter. hi h₁ 101 102.5 W₂ 104.2 ha 108.10 98.45 42 100.5 Wy 10 m 102.5 hu 105.7 12 97.35 99.80 101 hs 104 hi 10 m he 104 hi 106.5 1 hi

Q: The calculated reduced levels for a longitudinal section of the current smoothly curved land…

A: Tabulate the distance and the reduced levels.To find: Area below the formation level of .

Q: Q4/ The elevation of center line for a cross section of street project. If the design level for the…

A: Answer  We are given that design level for the proposed street is 25 m  desired elevation = 25 m…

Q: To control the elevation of a building, contractors must use or establish one or more benchmarks…

A: A differential leveling between station BMA to station BMC is given, with the RL of station BMA…

Q: 1. Solve for the elevation at BM2 Station BS FS Elevation BM1 5.87 392.25m TP1 7.03 6.29 TP2 3.48…

A: Calculate elevation of BM2?

Q: Given the following set of slope staking notes, find the fill volume between Stations 49+00 and…

A:

Q: Calculate Ve, Cp and Vp for the following notes. The base in fill is 20 ft and the base in cut is 30…

A: Data given Base width, cut = 30 ft Base width, fill = 20 ft Find: Ve, Cp, Vp

Q: Question 2. Below shown is the profile for a road construction at a station. This is a fill section.…

A: Find: Fill section area

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.