Question 2. Below shown is the profile for a road construction at a station. This is a fill section. Sometimes the letter C is used to designate cut and F to indicate fill for the vertical distance or depth. In other words, a point below the base would have a negative sign in a fill section. F 11.8 below corresponds to -11.8 ft. The baseline is 50ft. Calculate the area for the fill section. (Answer: 137.3 yd²) 50ft F 11.8 -42.5 F 14.3 -32.0 -25 25 010 F 15.8 0 25 25 Baseline F 16.3 65.4

Q: iven the following slope staking notes, the prismoidal correction factor in cu. Yds., to be applied…

A: Basic for cut = 48 ftbasic for fill =40 ftcut slope, s =2:5:1To find:Prismoidal correction factor

Q: Q#1: A profile levelling is carried out and consecutive readings were observed on staff rod along a…

A: Using the following formulae: RL+BS=HI HI-(IS/FS)=RL BS-IS=Rise/Fall Previous RL±Rise/Fall=Next RL

Q: The cost of the earthwork in excavation

A:

Q: Q2. After surveying a borrow pit, the surveyor produced the following pit grade below. What is the…

A: Given figure-

Q: Calculate the area between the sidewalk/proposed surface and the existing surface shown by the…

A:

Q: Given the following set of slope staking notes, find the fill volume between Stations 49+00 and…

A:

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 22+400…

A:

Q: From the following cross-section notes, complete the table below. Use prismoidal method. Road bed…

A:

Q: Prove that the scale ratio for discharge for a distorted model is given as pavietos adr Qp Qm = (L₁)…

A:

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.