Q2 Two chambers with the same fluid at their base are separated by a piston whose weight is 25 N, as shown in the Figure below. Calculate the gage pressures in chambers A and B. Please discuss the result comparing the gage pressures you obtained in chambers A and B. Calculation errors will not be tolerated. Solution procedure will be evaluated with the exact results. Please be careful. Piston A B Air Air D 50 cm 35сm 25 cm 38 cm E. Water 90 cm

Q: Water flows into the atmosphere from a nozzle and strikes a vertical plate as shown in the figure…

A: Diameter of pipe (D1) = 0.3m Area of pipe (A1) = Πd2/4 = 0.0706 m2 Diameter of the nozzle (D2) =…

Q: Air (1.23 kg/m³) flows past an object in a 2-m-diameter pipe and exits as a free jet as shown in the…

A: Given, ρ = 1.23 kg/m3 D = 2 m   NOTE : As per guidelines, first 3 parts are solved. Request you to…

Q: 10. Calculate the density, specific weight, and specific volume of chlorine gas at 25°C and pressure…

A:

Q: Calculate the pressure difference between the 2 points shown on the figure below (P1 - P2)? Fluid in…

A: Given :-       The pressure difference between 2 points ( P1-P2)           SG =13.6           Cross-…

Q: n the pressure at m is increased by 5.59 lb/in2, while the pressure at n remains constant, determine…

A:

Q: Q3. The soaking bin contains ethyl alcohol used for cleaning automobile parts. If the pressure in…

A:

Q: 2) Assuming we have a fluid with SG-0.6, and height of fluid in the piezometer tube equal to h=10m,…

A: To Determine Pressure at point M, P & S

Q: A 3 cm orifice plate is placed within a 4 cm pipe in which methanol at 20 °C (SG = 0.7884 and…

A: Diameter of the orifice = d = 3m   Diameter of the pipe = D = 4m   Specific gravity of the methanol…

Q: The mercury manometer indicates a differential reading of 0.30 m when the pressure in pipe A is…

A: Pressure diffrence has to calcluated

Q: In a pipeline with a diameter of 500mm, a venturi meter is installed. The ratio of the throat pipe…

A:

Q: what is the pressure (in Pa) at the higher center (P₂) if H=

A:

Q: The four pipes below have steady flow of an incompressible, ideal fluid with density ps. The…

A: Four manometers are given with the three pairs of options

Q: Flow rate of a fluid (p = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and diameter…

A: The density of the fluid, = 1000 kg/m3Flow rate = 800 mm3/sLength of tube = 2 mDiameter of tube =…

Q: The figure shows an inlet and outlet connected to a motor. If the pressure at A is 6.25 MPa and the…

A: step 1-

Q: ... EX, 7 The device shown in the figure is known as a venturi. In this specific venturi, the…

A:

Q: E Problem 3 As shown in the figure below, a weight (0.225 m³) is added to the top of the piston (5…

A:

Q: In fig. if H= 88 inches, the difference in pressure =---?(the fluid is water) Piezometer (static)…

A:

Q: The cage system shown in the figure is made of EC rod. The Flow Limit of the material is 180 MPa and…

A: To find diameter of rod EC

Q: Reg.no : 5393   Pb # 3: Refer to Figure 2. Assume that friction is negligible, that θ = 115o, and…

A: Given figure: