Q2: supported beam made of steel , E=200 Gpa shown in fig 2a loaded with concentrated load of p=10 kN . The cross section area shown if fig 2b, and the beam have the following dimension a = 3.2 m, b=1.6 m, c= 80 mm, t= 25 mm, h= 90 mm. Find the maximum shearing stress and the flexural stress of simply c/2 a b A Fig 2a Fig 2b B.

Q: Bar AB has a cross-sectional area of 1200 mm² and is made of a steel that is assumed to be…

A:

Q: Determine the magnitudes of the internal normal force, bending moment, and shear force acting on the…

A: P = 9 Kips  Q = 35 Kips  R = 22 Kips  e = 15 in

Q: 2) The strain in the x direction at point A on the A-36 structural-steel beam (E = 29,000 ksi,…

A: Given data : E = 29000 ksi and v = 0.318  Determine : 1 ) The applied load P ? 2 ) The shear strain…

Q: Determine the largest (allowable) compressive loadP (in kN) that can be supported by the aluminum…

A: Diameter of cyinder, D =200mmangle of plane aa with horizontal =25°Load applied =PFactor of safety,…

Q: A pin-connected truss is loaded and supported as shown. Each aluminum member has a cross-sectional…

A:

Q: A pin-connected truss is loaded and supported as shown. Each aluminum member has a cross-sectional…

A:

Q: The beam with cross-section shown carries a uniformly distributed load of intensity w over its…

A:

Q: pD/ the 931. For the state of stress shown in Fig. principal stresses and the maximum shearing…

A: Givenσx=80Mpa ζxy=30Mpa so the principal stress is given as σ1=+σx-σy22+ζxy2σ1=802+8022+302=90Mpa…

Q: of point B. The beam is subjected to the loading shown in Fig. 2. Determine the state of stress Ans.…

A: State of stress at B of Given beam of I section  Find bending stress and Shear stress at B###

Q: 1. For the W 21x 62 steel beam below determine the actual value of om in the beam and the maximum…

A: A simply supported beam at B and C, of length 30ft between B and C, with overhanging portion AB and…

Q: Q.3) A simply supported wide-flange (see figure below) beam of span length L carries a vertical…

A: Given : Section : W 10 X 30 L = 8.5 ft P = 5 kips  Alpha = 26.57 degrees We are asked to determine…

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.