Q2/ Moist air at I atm, a dry-bulb temperature of 105 "F, and a wet-bulb temperature of 75 of is enclosed in a rigid container. The container and its contents are cooled to 65 °F. a- What is the molar humidity of the cooled moist? b- What is the final total pressure in atm in the container? e- What is the dew point in °F of the cooled moist air?

Q: Q4) Write the relation between melting point temperature of ice with pressure? At 1 Atm, water melts…

A: Melting point is the temperature required for the solid to change its phase from solid to liquid.…

Q: 1) 1 kg of air is initially at 250.241 K and 239.459 kPa. It is heated to a state of 355.189 K and…

A:

Q: A sample of air occupies 145 L at 900 mm Hg. What pressure is required to compress the air to 90 L…

A: Answer is P2 = 1450 mmHg . Pressure required to compress is P2 = 1450 mmHg. Detailed Calculation…

Q: In feed condition, Explain the range of q (among partial vapor, cold liquid, saturated vapor at dew…

A: q is known as moles of liquid flows in stripping section per mole of entering feed. for saturated…

Q: Given: Two gray bodies: Body 1 at 200 C and Body 2 at 100 C with emissivity of 0.6 and 0.8…

A: Given that- Body 1 temperature= 2000C = 473K Emissivity, ε= 0.6 Body 2 temperature=1000 C= 373 K…

Q: Q2/ Moist air at I atm, a dry-bulb temperature of 105 "F, and a wet-bulb temperature of 75 of is…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: the following Question: problems: Use the psychrometric charts to answer I. The wet bulb and dry…

A:

Q: 2 ' rs² In rs r 4k T(r) = Ts2 + (rs? - r) - 2 k

A:

Q: 14A.5. Heat transfer from condensing vapors. (a) The outer surface of a vertical tube 1 in. in…

A: The ability of heat to move from one surface to another is measured by the heat transfer…

Q: a closed, rigid tank contains only water vapor and has a dew point of 50 Celsius. the total mass of…

A: Given, The dew point of water, Td = 50 °C The temperature of the water, T = 70 °C

Q: What does this graph show?

A: This question is based on data analysis.

Q: block (cube 10 cm aside) of ice is initially at a uniform temperature of -20°C. If it is placed over…

A: The heat transfer will occur from 5 faces as one is rest on plastic surface.To find the time…

Q: Determine the external pressure if ethanol boils at 60 °C?

A: The boiling point of Ethanol at new pressure(P2)=60oC To Calculate the pressure(P2)=?

Q: At the initial state, the pressure and temperature of water vapor in the metal tank were 20 MPa, 520…

A: Initial temperature of water vapor, T1 = 520ºC = 793.15 K Initial pressure of water vapor, P1 = 20…

Q: Carnot efficiency of a heat engine between the temperature limits of TH (Higher temperature) and TL(…

A: Carnot engine is a thermodynamic cycle that gives the maximum possible efficiency of a heat engine…

Q: If a heat pump works between-15°C and 50°C. Then, the coefficient of performance is... Select one:…

A:

Q: Which of the following is not an intensive

A: Intensive property is a thermodynamic property which does not depend on the amount of material in…

Q: Imagine gas in a piston – cylinder device. The fluid is compressed resulting to an increase in…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: (2.32) A feed stream to a chemical reactor consists of 0.2 kg/s of ammonia vapor at 300 K. Prior to…

A:

Q: Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible non flow…

A:

Q: A client has an airstream that is 150 ºC and at 1 atm of pressure that contains 50,000 ppm of…

A: Given data: Concentration of heptane in air stream = 50,000 ppm Heptane removed = 40 %

Q: In the virial EOS, the second virial coefficient is a function of a. temperature only b. pressure,…

A: Virial EoS are functions that states the pressure–volume–temperature (P-V-T)  behavior of pure…

Q: Find the volume of nitrogen gas when change heat at temperature 20 Co to 50 Coif that gas container…

A: Given data:  Initial temperature = 20 0C Final temperature = 50 0C

Q: Q1// A steel cylinder at 80 °F of length 12" is placed in a liquid nitrogen bath (-315 °F). If…

A:

Q: A concrete wall is insulated on one side and exposed to ambient air at 25°C on the other. If the air…

A: A concrete wall insulted on left side is exposed to ambient air.

Q: A surface is to be kept at 20°C(68 °F) with a fixed heat flux of 500W/m2, determine the driving…

A: Given data: Initial temperature of carbon steel pipe = 20 0C Heat flux = 500 w/m2 Length of the pipe…

Q: A natural gas has the following composition: Componont 0.75 0.10 C, i-C, n-C, i-C, n-Cs 0.05 0.04…

A: The composition of a natural is given. T = 200 0F P = 3,500 psia

Q: Cooking gas from petroleum is stored with a. thermal energy O b. chemical energy c. mechanical…

A: Cooking gas from petroleum source is, Select correct answer.

Q: The expansion of a hypothetical closed system takes place at a constant pressure with no change in…

A: First law of thermodynamics for closed system: dQ-dW=dEdQ-dW=dU+dEp+dEkas kinetic and potential…

Q: QI\Find the volume of nitrogen gas when change heat at temperature 20 C" to 50 C" if that gas…

A: Consider the normal pressure and temperature conditions and we also know the volume at this NTP…

Q: Determine the specific volume of superheated Refrigerant 134-a at 1.2 MPa and 80 °C, using (a) the…

A:

Q: On a clear night, when the effective blackbody temperature of the space is - 30°C, the air contains…

A:

Q: 7.52. Show that the friction heating in a hydraulic jump is given by = 8(Zz - Z₁)³ 42122 (7.67)

A: Friction heating is taken as the energy loss.

Q: 7. The temperature of a system rises by 70°C during a heating process. Express this rise in…

A:

Q: Water is poured into an insulating container. The water has mass m, = 1.2 kg and an initial…

A: Equilibrium temperature for the system is to be calculated.

Q: Kerosene: What is the energy content, in terajoules, of a tank containing 4.37×105 liters of…

A: Volume of kerosene = 4.37×105 L Density of kerosene = 0.81 g cm-1…

Q: ¡Hot water at 50°C is routed from one building in which 4. it is generated to an adjoining building…

A: If the cost of producing the hot water is $0.10 per kWh, the representative daily cost of heat loss…

Q: 3. In an adiabatic cooling tower 500 kg/min hot water, is to be cooled from 50°C to 35°C by using…

A: The mass flow rate of water to be cooled, mW = 50 kg/min The initial temperature of the water, T1 =…

Q: In a certain manufacturing process a certain Liquid gas under 14.7 psia pressure with has a normal…

A: