Determine the specific volume of superheated Refrigerant 134-a at 1.2 MPa and 80 °C, using (a) the ideal-gas equation (b) the generalized compressibility chart, (c) the steam tables. Also determine the error involved in the first two cases. (d) Can we consider the superheated vapor to behave as an ideal gas under the given temperature and pressure? why

Q: 10. A feed containing 3 wt.% dissolved organic solids in water is fed to a double effect evaporator…

A: Given that- In double effect evaporator, Solid in feed= 3 % =0.03 Concentrated solid= 20%=0.2 Enter…

Q: 1. Reverse feed double-effect evaporator is used to concentrate a feed of 10% solids to 20%. The…

A:

Q: I am to write a balance equation with phase labels for Haber process including heat energy. I am not…

A:

Q: A heat pump with refrigerant-134a (R-134a) as the working fluid is used to keep a space at 21 °C by…

A: Given information:   The working fluid used in a heat pump is a refrigerant R-134a.   Space…

Q: a) The vapour pressures of carbon disulphur (CS2) at the 180 ºC-240 ºC temperature range are:…

A: (a)   The data for the vapor pressure of CS2 in the temperature range of 180°C - 240°C is given as:…

Q: The results of air temperature measurement obtained a dry bulb temperature of 55 ° C and a wet bulb…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which…

Q: 1. At a specific volume of 100 m³/kg, the temperature of a water sample is 10°C. What is the phase…

A: Hi, according to our guidelines we are allowed to answer single question per submission. As you have…

Q: Show that h,dx h 2hx=L 3DL dx 0,

A: When a fluid flows over a cod or heated surface (plate), temperature field is set up in the region…

Q: "Consider a heat engine with a piston chamber that has a diameter of 30 mm, a cold reservoir at 285…

A: Heat engine of diameter 30 mm Cold reservoir temperature= 285 K Hot reservoir temperature = 350 K…

Q: Steady-state temperatures at selected nodal points of the symmetrical section of a flow channel are…

A: Given, The convection coefficient, hi= 500 W/m2.K ho= 250 W/m2.K

Q: 3. Air expands from 200 to 1000 cm3 in a cylinder while the pressure is held constant at 600 kPa. If…

A: Given that V1  = 200 cm3V2    = 1000 cm3constant pressure P = 600 KPaT1 = 20 C = 20 +273.15 =293.15…

Q: дт The Joule-Thomason coefficient of a gas is given by = 3.17- atm K др )н The gas was initially at…

A: The temperature of the gas is to be determined after it passed through the throttle.

Q: the following Question: problems: Use the psychrometric charts to answer I. The wet bulb and dry…

A:

Q: For practical reasons, oxygen and nitrogen are usually stored and distributed and argon at…

A: Given: Initially the nitrogen is stored as liquid nitrogen with conditions: Volume of the thermos,…

Q: Required information Consider the vapor-compression refrigeration cycle shown below with…

A: For a detailed solution, please see the attached files.

Q: How many phases are at point: A B X

A: The graphical representation of phases is phase diagram. A phase diagram gives the transition…

Q: Methane is heated in a steady-flow process at approximately atmospheric pressure. 1000 kJ of heat is…

A:

Q: The results of air temperature measurement obtained a dry bulb temperature of 36 ° C and a wet bulb…

A: Given, Dry bulb temperature, Tdb = 36 °C Wet bulb temperature, Twb = 31 °C

Q: A bottle of fresh orange juice is taken from a fridge at 40C and left in a room with an ambient…

A: It is given that,initial temperature of bottle ambient temperature overall heat transfer…

Q: Find and reference a semi-empirical correlation for convective heat transferfrom the literature.…

A: The objective of the question is to find a semi-empirical correlation for convective heat transfer,…

Q: 1-a Sub-cooling of the liquid can takes place either inside or outside the condenser, discuss in…

A: Sub-Cooling is the process of cooling the condensate further below its saturation temperature. It is…

Q: A) Calculate the entropy of sublimation(Delta Ssub), and entropy of vaporization (Delta Svap) of…

A: (A) Given, The heat of vaporization of water, ∆Hvap = 45.07 kJ/mol The heat of sublimation of water,…

Q: A saturated solution containing 1500 kg of potassium chloride at 360 K is cooled in an open tank to…

A:

Q: Water is present in its vapor form. In order for this vapor to be able to condense while only…

A: To choose the option that best captures the term for water vapor, which condenses only by reducing…

Q: Q 3) A) What is the physical significance of the two constants that appear in the van der Waals…

A: Since you have posted multiple independent questions in the same request, we will solve the first…

Q: 5. Schmidt is the ratio of A. Molecular momentum diffusivity to molecular mass diffusivity B.…

A:

Q: A client has an airstream that is 150 ºC and at 1 atm of pressure that contains 50,000 ppm of…

A: Given data: Concentration of heptane in air stream = 50,000 ppm Heptane removed = 40 %

Q: .Steam at a rate of 200 kg/h is used to eat a stream of gas flowing on the tube ide of a heat…

A: The rate of heat transfer can be determined by calculating enthalpy at inlet and outlet. Now steam…

Q: Please help me with this question

A: In chemical processes, the operating pressure and temperature are crucial parameters for optimizing…

Q: Convert a thermal conductivity of BTU 0.03- to s. K.m °hr. °F.ft Given: 0.03- BTU hr.F.ft Required:…

A: ⇒1 btu=1055.056 J⇒1 hr=3600 sec⇒∆°F=∆K⇒1 ft=0.305 m⇒thermal conductivity, K=𝓠.∆xA.∆T

Q: Applying the phase rule at point d, F= ? 1.) 1 2.) 2 3.) 3 4.) 0

A: Given Data:  Applying phase rule and given PT diagram. Find Degree of Freedom at point d.

Q: Example 2.4 Air is in a rigid tank of volume 1m' at initial pressure of 500kPa and temperature of…

A:

Q: Gases behave as an ideal gas at low densities (ie., low pressure, high temperature), what is the…

A: When Gases Behave as an ideal gas at low density then Critical Temperature of Ideal Gas is always…

Q: .30 mol of an ideal gas expands in the diagram. The ideal gas goes through an isochoric heating…

A: Ideal gas law gives the relation between Pressure, Volume, Temperature, Number of moles, and the Gas…

Q: 3.51 WP Referring to Fig. P3.51, water contained in a piston-cylinder assembly, initially at 1.5 bar…

A: Given Initially P1=1.5bar Quality=20% Patm=1bar Water converted to saturated vapor Question figure…

Q: Building in Nassiriah city is air conditioned with the following assumptions: Sensible heat load…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: What is the role of high temperature and pressure in the making of petroleum? a. For decreasing the…

A: Explanation If we are providing high temperature and pressure, it creates a good suitable condition…

Q: On a clear night, when the effective blackbody temperature of the space is - 30°C, the air contains…

A:

Q: With reference to the following diagram, explain the sequence of events of heating water from 20 °C…

A:

Q: Help with the following question please answer all parts and double check your answer.

A: The general energy balance for a closed system is:∆U + ∆Ek + ∆Ep = Q + W where:∆U is the change in…

Q: A) Choose the correct answer of the following: 1- A saturation state is a state from which a change…

A: Answer B) Given:  Pressure =P=40bar Temperature = T =243 K  Vessel Volume = 0.5 m3 Volume of Liquid…

Q: 3. In an adiabatic cooling tower 500 kg/min hot water, is to be cooled from 50°C to 35°C by using…

A: The mass flow rate of water to be cooled, mW = 50 kg/min The initial temperature of the water, T1 =…

Q: How many kg of solid fuel is required to completely vaporize 1 liter of water at 760 mmHg? The…

A: Volume of water = 1 liter  Heat capacity of water(Cp) = 4.184 kJ/kg Latent heat of water = 2256…