Q2/ Arwana canal with rectangular cross section. The wall of the channel (4-2) has a water depth of 0.4 m. The amount of water that flows inside the canal is 360 m within two minutes. The slope changes to become the horizontal canal and the water level in it was 35 m. Will a hydraulic jump occur when the slope changes and why? 35 35 34.5 0.4

Q2/ Arwana canal with rectangular cross section. The wall of the channel (4-2) has a water depth of 0.4 m. The amount of water that flows inside the canal is 360 m within two minutes. The slope changes to become the horizontal canal and the water level in it was 35 m. Will a hydraulic jump occur when the slope changes and why? 35 35 34.5 0.4

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 2.0m diameter concrete pipe on a slope of 0.005 is to carry water at a normal depth of 1.5m. Determine the flow velocity and flow rate Take n=0.014 also determine q when ho=0.75 and h1=1.0m
The asphalt - lined trapezoidal channel carries 300 cfs of water under uniform flow conditions when S = 0.0015. What is the normal depth? Use n = 0.016. bo L 6 ft- Y'n 50°
A trapezoidal channel with a bottom width of 5m and side slope of 1V:2H is constructed to convey a steady discharge to a hydropower installation. This is made up of concrete with a Manning's n = 0.016 and bed slope of 3V:2000H. a. Determine the discharge and velocity if the discharge has a 2m-depth of water? b. Calculate the depth if discharge is 35m³/s? c. As shown below, when flooded, the flow goes over the top of the channel. If the flood channels are 10 m. wide and with side slopes of 1V:3H, and roughness is n=0.035, what is the discharge for a flood level of 4m? 14.5 15.0 14.5 region 2 region 1 region 3 4 10 10 5 2.
a trapezoidal channel with side slope of 1:1 is to carry a discharge of 45 m3/s and a mean velocity of 0.6m/s. bottom width of section is 5.30 m. if n=0.015, compute the ff: 1. find the depth of flow. Answer: 6.41 m 2. length of the canal section if it drops a height of 3m at its end. Answer: 174,835m 3. Average shearing stress at the boundary. Answer: 0.539 Pa
The Aqueduct canal has side slopes at 45° to the horizontal base of the channel and conveys water at a depth of 1.5m. a. Calculate the width of the base.b. Calculate the gradient of the channel bed to discharge 2.54m3/s with a mean velocity of flow of 1.56m/s. Take Chezy C = 66.
Water is flowing in the spillway chute with a discharge of 150m^3/s which has a rectangular section and is 15m as shown. n=0.015. a.) What is the depth of flow at the bottom of the 3% slope at A? b.) What would be the required depth of tailwater at section B to cause a hydraulic jump to cause a hydraulicjump to form on the flat slope? c.) Determine the horsepower degenerated due to the jump?
B7