Q2: Answer two of the following questions:a) For the circuit shown in fig.(2),v = 10eV and i = 0.2e-4t A,t> 0Fig.(2)(a) Find R and C.(b) Determine the time constant.(c) Calculate the initial energy in the capacitor Wc. (W-½ Cv²)(d) Obtain the time it takes to dissipate 50 percent of the initial energy.b) Non-sinusoidal voltage applied on 1052 resistance with consumed power 520w and thecurrent i(t)=10sinwt+I3 sin3wt+0.5 sin5wt Amp. Find the value of 13 and the voltage effectivevalue.c) For the circiut shown in fig.(3), the switch has been opened for a long time. It close at t=0,find VL(t) for t>0.Fig.(3)24 V10 V2H201-069RC+ al

Note : Since all the above mentioned questions are not interlinked to each other hence we need to…

Q2: Answer two of the following questions: a) For the circuit shown in fig.(2), v = 10e V and i= 0.2e-4t A,t> 0 Fig.(2) (a) Find R and C. (b) Determine the time constant. (c) Calculate the initial energy in the capacitor Wc. (W-½ Cv²) (d) Obtain the time it takes to dissipate 50 percent of the initial energy. C

Q2: Answer two of the following questions: a) For the circuit shown in fig.(2), v = 10e V and i= 0.2e-4t A,t> 0 Fig.(2) (a) Find R and C. (b) Determine the time constant. (c) Calculate the initial energy in the capacitor Wc. (W-½ Cv²) (d) Obtain the time it takes to dissipate 50 percent of the initial energy. C

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

the switch takes 2 seconds in position ''a'', after exactly two seconds it moves to position ''b'', takes 3 seconds in ''b'' and after exactly 5 seconds it moves to position ''c'', where it remains for the rest of the time.Plot the curve of the voltage on the capacitor vs time in the interval -5 s<t<10 s. Find the voltage v(0),v(2),v(5)v(t)
In the given circuit; an initial voltage V,-10 V exists across the capacitor. Calculate a) The time constant of the circuit b) The voltage across the capacitor after t= 2t c) The current through the capacitor after t= 2t 4T mf
ЗА 34 kN ER 30 mH The switch in the circuit shown in (Figure 1) has been in position 1 for a long time. At t = 0, the switch moves instantaneously to position 2. Find the value of R so that 32% of the initial energy stored in the 30 mH inductor is dissipated in R in 21us.
A 3.0 MΩ resistor and a 1.0 μF capacitor are connected in series with an ideal battery that has an emf E = 5.0 V. After 1.0 s after the initial connection is made, find the rate at which(a) the charge on the capacitor is increasing (inC/s),(b) energy is being stored in the capacitor (inJ/s),(c) thermal energy is appearing in the resistor (inJ/s), and (d) energy is being delivered by the battery (inJ/s).
C C a R The switch is placed at position a. The capacitor is being charged. The switch is placed at position b. The capacitor is being discharged. (1) Charging the capacitor: What is the equation for the charge q (t) of the capacitor as it is being charged in the RC circuit? Give your answer in terms of R, C, ɛ, and t? What is the equation for the current I (t) as a function of time when the capacitor being charged? Give your answer in terms of R, C, ɛ, and t? (2) Discharging the capacitor: What is the equation for the charge q (t) of the capacitor as it is being discharged in RC circuit? Give your answer in terms of R, C, ɛ, and t? What is the equation for the current I (t) as a function of time when the capacitor being discharged? Give your answer in terms of R, C, ɛ, and t? (3) What is the equation for the time constant for charging and discharging the capacitor?
8. A 62.5-µf capacitor is connected in series with a 200,000-ohm resistor and to a 250-volt d-c source. (a) Write the expression for the charging current following the closing of the switch. (b) What is the initial charging current? (c) Calculate the time constant and the charging current at t = t. (d) What will be the initial rate of current change?
For the circuit shown in the following figure, if L= 20 H, Va-28 V, and Re 20 0, answer the following 2 questions: i(1) R Vou(t) L At what time the inductor is 25% charged from its steady state charging energy. Oa. 0.555 s Оb. 1.083 s Oc. 0.866 s Od. 0.693 s At what time the maximum power is delivered to the inductor. Oā, 1.083 s Оb. 0.555 s Oc. 0.866 s Od. 0.693 s ll
if the current flowing through a 75mH has the waveform shown belowa.) Determine the equation of the current for 0<t<1,1<t<3,3<t<4 secb.) what will be the equation/s representing the voltage that develops across the inductor terminals for the same time interval?c.) Sketch your results from part b. please help me, and please show the complete solution so that I will understand the process.
The capacitors in the figure are discharged, the switch closes in t=0 A) determine the equation for vcB) determine the time constant C) determine vc for a time constant
1. A voltage is being applied across a 0.2 mH inductor as shown below. The current through the inductor at t = 0 is known to be i(0) = 10.0 A r (mv) 0.2 mH t(s) a. Find the current through the inductor as a function of time for t20 (i.e. find i(t) for t>0). b. Find the energy stored in the capacitor at t=1.5 sec.
The current across a 10 mH inductor is given below: a) Find the corresponding voltage. b) Over the specified time interval determine the power transferred to/from the inductor. c) Determine the instant in time when the power transfer into/out of the inductor maximum/minimum? is d) What is the energy stored in the inductor? -2 i(mA) 100 0 2 4 t(s)
Q4/Choose only two (2) of the following branches:- A / Find V. (t) for the circuit in figure below of t 20 1K2 Ak () 100V 2k2 25mA 50nF B/ Find the voltage across the capacitor as a function of time for t>o for the circuit in figure .Assume steady – state condition exist at t=0 20ν (-) o.5H 2F