GROUP 8 LRC series circuit connected in series with resistance of 4 ohms, a capacitor of 26 farad and an inductance of ½ henry has an applied voltage E(t) = 16 cos 2t. There is no initial current and no initial charge on the capacitor' a) Find the expression for the current I(t) flowing through the circuit at any time t b) If the applied voltage is removed, what will happen to the current flow after a long time? c) If the applied voltage is charged to E(t)-16 cos 6t, what will happen to the current flow?

GROUP 8 LRC series circuit connected in series with resistance of 4 ohms, a capacitor of 26 farad and an inductance of ½ henry has an applied voltage E(t) = 16 cos 2t. There is no initial current and no initial charge on the capacitor' a) Find the expression for the current I(t) flowing through the circuit at any time t b) If the applied voltage is removed, what will happen to the current flow after a long time? c) If the applied voltage is charged to E(t)-16 cos 6t, what will happen to the current flow?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What is the effect in the overall capacitance, stored charge and energy of a network of identical capacitors when they are connected in series and energized by a constant voltage source (battery)
A 500 nF capacitor is connected in series with a 100 kohm resistor and the circuit is connected to a 50V, d.c. supply. Calculate the initial value of current flowing, the value of current 150 ms after connection, the value of capacitor voltage 80 ms after connection, and the time after connection when the resistor voltage is 35 V.
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged capacitor of capacitance C= 17.9 µF through a resistor of resistance R = 22.7 Q. At what time is the potential across the capacitor equal to that across the resistor? Number i Units S R C
Find the equivalent inductance as seen from the terminals shown in the figure.
2: A 10Q resistance is in parallel with 50µF capacitance and the current through the capacitance is: (ic=2sin100t+1.5sin200t+1.2sin400t) Ampere. Find the total dissipated power by the circuit? (Ans.: P,=9305W) Jel 50120ein 100oti20cin2000 Volt is oprlied
Find the Equivalent Capacitance between P and Q from the figure below
Regarding this circuit I was wondering what is the current / voltage relationship with the inductor and capacitor ?
Picture shown three capacitors with capacitances C1=6.00μF,C2=3.00μF,C3=5.00μF . The capacitor network is connected to an applied potential Vab. After the charges on the capacitors have reached their final values, the charge Q2 on the second capacitor is 40.0 μC. Part A What is the charge Q1 on capacitor C1? Part B What is the charge on capacitor C3? Express your answer in microcoulombs to three significant figures. Part C What is the applied voltage, Vab? Express your answer in volts to three significant figures.
A source-free RC circuit contains a 100 ohm resistor and a 1 mF capacitor initially charged to 5 volts. What is the voltage across the capacitor after a time of 0.1 seconds has elapsed. Show all work
In a RC charging circuit, given R = 150 Kohm, Supply voltage = 15 V and voltage across the capacitor is 5.6 V after time t = 12 ms. Find the value of the capacitor used.
Which of the following is TRUE? O a) The major reason for using electrolytic capacitors is that they have a very low a) capacitance but can handle very low voltages. O b) Increasing the distance between the plates of a capacitor would yield a higher capacitance. OdA capacitor is rated according to its maximum allowable voltage and c) capacitance value. d) Electrolytic capacitors are non-polarized.