Q2: A simple VCRC using R-134a operates with a condensing temperature of 30°c and an evaporating temperature of -20°c .The system produces 50 kw of refrigeration. Determine the : a) Thermodynamic property values at the four main state points of the cycle, b) COP, c) Rate of refrigerant flow.

Q2: A simple VCRC using R-134a operates with a condensing temperature of 30°c and an evaporating temperature of -20°c .The system produces 50 kw of refrigeration. Determine the : a) Thermodynamic property values at the four main state points of the cycle, b) COP, c) Rate of refrigerant flow.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

R-134a is used as the working fluid in the ideal two-stage vapor compression refrigeration system. Working pressures for evaporator, evaporation chamber and mixing chamber, condenser are given as 1, 4 and 9 bar, respectively. If the cooling load is 5 tons a) the compressor power on the low pressure side (kW) b) the mass flow rate of the fluid entering the mixing chamber (kg/min) c) find the COP of the entire cycle.
The following image describe a single-flash geothermal power plant. We have the follow informations about the system: The flash chamber (throttling valve) is a isenthalpic device The system is adiabatic The power generated by the turbine is 10kW The pressure and temperature at point 4 are 50 kPa and 100°C respectively The pressure at separator is 500 kPa The separator has the function of separating the phases of a saturated mixture The mass that exits the system through the separator is 5 times the mass that exits the turbine. The pressure at point 1 is 1 MPa If all the information is sufficient, fill in the table below and plot all the points on a T x v graph.
Given the ideal compression refrigeration cycle steam with refrigerant 134a as fluid work, as shown, and which operates between the pressure limits of 120 and 800 kPa.Given a rate of heat removal from space refrigerated of 30 kJ/s, determine:a) The mass flow of the refrigerant, in kg/s.b) The minimum necessary power input, in kWc) Show the T-s diagram of the cycle.
A Carnot vapor refrigeration cycle operates between thermal reservoirs at 40 ⁰F and 100 ⁰F. Determine the coefficient of performance.
The coefficient of performance (COP) for a vapor compression cycle chiller is 8. If the chiller can produce 46 tons of cooling, how much electric power (in kW) does the chiller consume? Fill in the electric power of the chiller in kW.
For each control volume analyzed, the thermodynamics model is the steam tables, the process is SSSF (steady state, steady flow), and the changes in kinetic and potential energies are negligible. Consider a reheat cycle utilizing steam. Steam leaves the boiler and enters the turbine at 4 Mpa, 400°C. After expansion in the turbine to 400 kPa, the steam reheated to 400ºC and then expanded in the low pressure turbine to 10 kPa. Determine the cycle efficiency.
Superheated steam at 18 MPa, 560 °C enters the steam turbine. The pressure at the exit of the turbine is 0.06 MPa and saturated liquid water leaves the condenser at 0.06 MPa. Pressure is increased to 18 MPa again after the pump. Find: (a) Sketch the process on a T-s diagram. (b) The net work per unit of steam flow in kJ/kg. (c) Heat transfer to steam passing through the boiler, in kJ/kg.
1. A refrigerant system using refrigerant 22 is to have a refrigerating capacity of 60 kW. The evaporating temperature is -10°C and the condensing temperature is 42°C. Determine the: • Enthalpy at each point of the cycle in kJ/kg • Refrigerating Effect in kJ/kg Compressor work in kJ/kg • Energy rejected in kJ/kg • Mass flow rate of refrigerant in kg/s • Compressor power in kW • Heat rejected in kW • Coefficient of Performance Note: Draw the P-h Diagram with labels. Show your system balancing for checking.
Q6) A refrigerator with R-12 as the working fluid has a minimum temperature of -10°C and a maximum pressure of 1 MPa. Assume an ideal refrigeration cycle. Find the specific heat transfer from the cold space and that to the hot space, and the coefficient of performance. [107 kJ/kg, 133.9 kJ/kg, 3.98]
a. Sketch the process on a P-V diagram b. Determine the rate of heat transfer from Boiler ( Qcv/m 1-2, in KJ/kg) c. Determine the rate of heat transfer from condenser ( Qcv/m 3-4, in KJ/Kg) d. Using the Clausius inequality to determine if the cycle is internally reversible, irreversible, or impossible. e. Determine the thermal efficiency of power cycle f. Determine the maximum thermal efficiency of power cycle ( Carnot Efficiency) g. Due to part (e & g) this cycle is___________ ? - internally reversible -internally irreversible -impossible
The following data for the R-12 refrigeration system as shown are as follows: Evaporator 1 0 OC 30 TOR Evaporator 2 -10OC 20 TOR Evaporator 3 -20OC 10 TOR Condenser 20OC Assume simple saturation and isentropic compression and determine the following: a) Draw the h-s diagram b) The refrigerant flow in each evaporator c) Total work of compression, WC in kW d) Heat rejected in the condenser, QR in kj/min e) Coefficient of performance