Q2) A hydro-electric generating plant is supplied from a reservoir of capacity 20000000 m3 with a head of 200 m. The hydraulic efficiency of the plant is 0.8 and the electric efficiency is 0.9. What is the total * .available power output in 10 hours

Q2) A hydro-electric generating plant is supplied from a reservoir of capacity 20000000 m3 with a head of 200 m. The hydraulic efficiency of the plant is 0.8 and the electric efficiency is 0.9. What is the total * .available power output in 10 hours

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A generating plant has a maximum capacity of 100 kW and costs Rs 2,000,000.The annual fixed charges…

Q: Hydro power plant costs Tk. 45×101º with maximum capacity of (x+6) MW.

Q: 9. A central station is supplying energy to a community through two substations. Each substation…

Q: A 100MW hydro-electric station is supplying full load for 10 hours in a day. The water is supplied…

Q: A man has a body resistance of 600 N. How much current flows through his ungrounded body: (a) when…

A: The solution can be achieved as follows.

Q: Q A power station with capacity of 800 kW is to supply two loads (A & B). The daily load curve of…

A: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining part…

Q: 9. A central station is supplying energy to a community through two substations. Each substation…

A: Given maximum daily recorded demands are -

Q: 1. A pump driven by 240V motor lifts 1000 ft / min against a head of 50 m of water. The efficiency…

A: Given pump driven by motor Voltage v=240 vMotor lifts 1000 ft3/minHead h=50 mThe efficiency of the…

Q: V. Peak-to-peak voltage for 40VAC is 80

Q: Q1. High load factor indicates Ocost of generation per unit power is increased O total plant…

A: Here question is high load factor indicates what

Q: 9. A central station is supplying energy to a community through two substations. Each substation…

A: The solution can be achieved as follows.

Q: A Hydroelectric Plant has a Turbine and Generator with an efficiency of 86 %. If the dam has a head…

Q: In electric power systems, all the following parameters will be reduced after improvement of power…

A: To choose the correct answer

Q: 7. A power station has to meet the following load demand : 50 kW Load 4 between 10 A.M. and 6 P.M.…

A: The solution can be achieved as follows.

Q: A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the…

Q: A steam turbine generator is designed to generate 5.5MW of electrical power at a 6300V, 50HZ and…

Q: Solve the problem below. When solving, use all possible decimal places. However, express your final…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: The energy that "sloshes in and out" of a load without causing any net power transfer is called the…

A: Power:- Power can be defined as the amount of work completed in a given amount of time. Watt (W),…

Q: The cost characteristic of two units in a plant are: 04 *PG1 PG1-160 PG1+ 400 RO/h and 0.45 PG2 PG2…

A: Given cost characteristics are: C1 = 0.4PG12+160PG1+400, C2 = 0.45PG22+120PG2, PG1=PG2=100MW.

Q: SOURCE TRANSFORMATION VS RA RB Do not include the unit. The answer must be in 2 decimal places. IS…

A: We need to find out the current through given resistor in the given circuit by using of source…

Q: Which renewable energy source is not from the sun? O a. geothermal O b. wind O c. biomass O d. wave

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Suppose 300 gal/min of water is taken from a creek and delivered through 1000 feet of 3-in-diameter…

Q: A power station of 4 MW has an overall efficiency of 0.35 and a fuel calorific value of 7500…

A: Given, power=4 MW Overall efficiency (η)=0.35 Fuel calorific value= 7500 k.calorific/kg units…

Q: The power triangle of a transmission system is shown below, S in KVA Q in Kvar P in kW The current…

A: it is given that current power factor = 0.866 lagging it is asked what we have to do to change it to…

Q: Problem Statement: For a 50MW power plant, with a cycle efficiency of 44% do we lock in a long-term…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Referring to the Figure 2, compute the following values, given that the operating frequency is 60Hz…

A: Given that Voltage E= 120 V Frequency, f=60 Hz A circuit is shown below. Find inductive reactance,…

Q: A base load station having a capacity of 15 MW and a standby station having a capacity of 19 MW…

Q: The current to a pure resistance load is given by the equation i=10sin314t. Calculate the…

Q: What is the value of real power supplied by the source in the figure? 62 30/0° V rms 42 3031.4 2007…

A: Impedance of the circuit :- 6+(4∥(-j2))=6.8-j1.6=6.98∠-13.24o So current supplied by source =…

Q: An electric geyser/electric storage tank water heater is used to raise the temperature of 150 litres…

A: The solution can be achieved as follows.

Q: PAKIRAM DAM Hydroelectric station delivers a load of 30 MW for 8 hours with a head of 100 m. It…

A: in this question we need to find a volume of water needed to generate the energy consumed by load.

Q: A single-phase energy meter having meter constant of 200 rev/kWh is operating on 230V, 50 Hz supply…

A: Energy meter constant K = 200 rev/kWh Load current = 10A The relation between the energy consumed…

Q: End product of Thermal power plant is O a. Smoke and Ash O b. Ash and Electricity O c. Smoke and…

A: To find out the correct answer

Q: 1) Voltage and current waveforms for a certain load are shown in Figure 1 parts a and b…

Q: a hydroelectric plant has a turbine and generator with an efficiency of 90%. if the dam has a head…

A: The power supplied by a plant, (the number of watts), is the rate at which it delivers energy: the…

Q: Q1 what is the main parts of Energy meter

A: As per our policy we can provide solution to first question only. Energy meter: The meter which is…

Q: pick one of the following renewable energy sources and justify the selection against the other…

A: Wind energy : Wind energy is the energy which is produced by wind it is the means by which the wind…

Q: Calculate the per-unit values of the elements according to the base values of 25MVA and 220kV in…

A: Calculate the per-unit values of the elements according to the base values of 25MVA and 220kV in…

Q: A base load station having a capacity of 18 MW and a standby station having a capacity of 20 MW…

A: Given: Installed capacity of standby unit =20 MW Installed capacity of base load plant =18 MW…

Q: An energy meter having a meter constant of 1200 rev/kwh is found to make 2 revolutions in 50…

Q: 202310_AUT105.21B Auto Electricity & Electronics Watt's Law 1 V 12 V R V 0.80 P R2 I 0.80 R3 Ⓒ…

Q: ANSWER THE FOLLOWING PROBLEM: MAKE SURE TO SHOW YOUR COMPLETE SOLUTION AND ANSWER MUST BE IN FOUR…

A: Here given three loads a) lamp load 10 kW a unity power factor (b) motor load of 80 kVA at 0.8 power…

Q: A 20 kW electric roof top A/C unit (RTU) is 10 years old, and has a COP of 2.0 . It operates at full…

A: Given values are =

Concept explainers

Electrical Power Generation

In an electric power generator, one type of energy is converted into electrical energy. Power-generating systems are simply a combination of potential or stored energy that is converted to provide kinetic energy, which, in turn, generates electrical energy for use in engines, lighting, heating, and other benefits of modern life.

Question

Q2) A hydro-electric generating plant
is supplied from a reservoir of
capacity 20000000 m3 with a head
of 200 m. The hydraulic efficiency of
the plant is O.8 and the electric
efficiency is 0.9. What is the total
.available power output in 10 hours

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Power Station and Its Characteristics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

SOURCE TRANSFORMATION VS RA RB Do not include the unit. The answer must be in 2 decimal places. IS Transform the current source into its equivalent voltage source. If VS=6 volts; Is=4 mA; RA=1 kohms; RB-4 kohms, what is the current thru RB in mA? ...
Design a solar tower power plant and concentrating solar power plantfor electric generation explain using diagrams
Q1 : :A power station with total capacity of 25 kW and is to supply three loads A, B and C The daily load of the loads A , B and C as follow:- Time (hours ) Mid night-7am 7am-6pm 6pm-7pm 7pm-9pm Load A (W) Time (hours) Mid night-9am 9am-12pm 12pm-5pm 5pm-7pm 7pm-mid night 9pm-mid night 200 No load 1500 5000 800 Load B (W) 600 2500 1500 No load 4000 Mid night-6am 6am-12pm 12pm-2pm 2pm-11pm 11pm-mid night Load C (W) 400 1600 5000 3600 600 Draw load curve of total power station and Find i- Load factor of total power station ii- Plant use factor of total power station iii-Diversity factor
O:28)
Justify only three of the following: (a) low efficiency of the steam power plants, (b) low efficiency of the gas power plants, (c) high running cost of deasil plants (d) using the surge tank in hydroelectric plants
7. Ohm's Law states that, for a steady current, the current in a circuit is total emf acting in the circuit and is proportional to the proportional to the total resistance. 8. is the rate of doing work, or rate of expenditure of energy, and its unit is
Evaluate (130 points); Use 3 decimal places. 1. The annual load of a substation is given in the following table. During each month, the power is assumed constant at an average value. Find the (a) average load and (b) the annual load factor. Annual System Load January February March 8 Y 4 April May 26 2 6 2, Tv June 12 sing July 14 phas August 14 idea September 10 imp October 8 5Y5 November December 68 6 ma del
Q2/ The following demands in a power plant as: Group 1:300 kW between 7 A.M. and 8 P.M Group 2: 150 kW between 5 A.M. and 9 A.M Group 3: 100 kw between 5 A.M and 4 P.M Group 4: 200 kw between 9 A.M and 4 P.M and then between 4 P.M and 5 A.M plot the daily load curve duration curve and Calculate 1- Units generating per day. 2-load factor 3-diversity factor?
2. Draw and Explain Schematic diagram of Geo Thermal power plant. Discuss its disadvantages.