Q2: A 60 mm diameter pipe contains glycerin (sp.gr =1.258) flowing at 8.5 m'/hr as shown in the figure. What is the head loss for theses pressures? 36 utm 12 a

Q: What are the liquid and vapor flow rates for the bottom and distillate streams

A:

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75…

A:

Q: 4. Rework inviscid flow past a cylinder in terms of the stream function y.

A: The inviscid flow past a cylinder in terms of stream function is to be mentioned.

Q: A 4 inch Sched 40 steel pipe carries crude oil at 80°C. The crude oil has a dynamic viscosity of 1.2…

A: Given: 4 inch Schedule 40 steel pipe dynamic viscosity μ =1.2 x 10-2 Pa·s density ρ= 680 kg/m3

Q: z=L 11 KR II %3D 3. %3D %3D r R Vz I3D II AR II z-0

A:

Q: 5. A Pitot tube in the pipe in which air is flowing is connected to a manometer containing water as…

A: Given that- Manometer difference in water level, x=87.5 mm= 0.0875m Tube coefficient, CP=0.90…

Q: An oil-water mixture is separated in a decanter. The properties of oil and water are summarized in…

A: For oil,For water,

Q: Nitrogen flows through a 4 in. x 6 in. rectangular duct at a rate of 2280 ft/s. What is the Reynolds…

A: Firstly hydraulic diameter was calculated for the rectangular duct and the Reynolds number is…

Q: 4. Two vessels are connected to a differential manometer using mercury, the connecting tubing being…

A:

Q: Determine the resistance in each scenario presented. Explain whether the resistance is linear or…

A: To find:a) whether the flow is laminar and the resistance.b) Pump resistance from the pump curve.c)…

Q: Q: An open cylindrical vessel of (20 cm) diameter and (100 cm) long contains water up to a height of…

A: Given diameter of open cylindrical vessel of =20 cm length of open cylindrical vessel of =100 cm…

Q: The velocity profile of a fluid in a horizontal circular pipe having a radius R is found as; Vz =0.4…

A: Given data: Velocity profile for a fluid in a circular horizontal pipe is given by the following…

Q: What is fluid power requirement of a cyclone seperator and how is it calculated?

A: A cyclone separator is used to separate the solid dust particles and the particulate matter from the…

Q: Q5/ Over a 30 m length of a 150 mm vacuum line carrying air at 295 K, the pressure falls from 0.4…

A: Given- L=30m D=150mm T=295K P1=0.4 kN/m2 P2=0.13 kN/m2 ε/D=0.003 μair=1.8×10-5Pa.s Find-flow rate

Q: 8. Oil flows in the pipe shown in figure. The orifice in the pipe has a coefficient of discharge of…

A: The orifice meter is a flow measuring device. The difference in pressure gives the flow rate of the…

Q: : Determine the pressure difference between the two points in figure below Oil (S=0.75) X- ----- S,…

A:

Q: Q1: Air flows in a pipe 10 mm diameter and 120 cm length at 0.25 MPa and 25 °C. if the exit pressure…

A:

Q: average speed of air in the 450 × 350 duct? ume flow rate in m³/s and mm³/hour. What is the rate of…

A: Given: Follow the notation assigned to the given figure;

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: 9. Glycerin (SG = 1.26) and u = 1.49 Pa.s) flows through a rectangular conduit 300 mm by 450 mm at…

A: Given that- For glycerin Specific gravity, SG=1.26  Absolute viscosity, μ=1.49 Pa.s=1.49 kgm/s Width…

Q: 14. For a cyclone of diameter 0.2 m with a tangential factor is (a) 2250 (b) 1125 (c) 460 01 13 at…

A: Given values:Cyclone Diameter (D) = 0.2 mTangential Velocity at the Wall (V) = 15 m/sGravitational…

Q: Calculate the Reynolds number for the flow of: 1) A tunnel glacier with density of ice 900kgm-3,…

A:

Q: A centrifuge bowl shall separate 2 immiscible liq, SG = 1.1 & SG = 0.9  The diameter inside of the…

A: Given Data  The specific gravity of the two immiscible liquids are given  as :SG = 1.1 , Therefore,…

Q: 2 - What is the use of orifice meter?

A: The flow of fluids is based on density, viscosity, flow rate, etc. These flow rates are measured…

Q: A water pipe is connected to a double-U manometer as shown in Figure below at a location where the…

A:

Q: Q4: a) Determine the valve lift & valve dimensions of an engine from the following data: Bore 140…

A: To determine the valve lift and valve dimensions of an engine, we need to use the provided data and…

Q: 1. An incompressible fluid of kinematic viscosity v= p/p = 10-4 m²/s flows steadily through a…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: calculate the largest discharge for which the flow will be definitely laminar Water flows in a 2 cm…

A: This question is based on fluid mechanics. The flow in consideration is Laminar flow. Data given :…

Q: Q5) Explain the major and minor losses? Then solve for the parallel pipes system shown below, a pump…

A:

Q: For the configuration shown in Figure 1, calculate the weight of the piston if the gage pressure…

A:

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: Exz: water at 1SC Hows between tow large plate at avelocityof 15 ms the plates are seperated by…

A:

Q: P.4.14 Water (density 1000 kg/m', viscosity 1 mNs/m²) is pumped through a 50 mm diameter pipeline at…

A: Case 1: Flow of water through pipe Mass flow rate of water, mW = 4 kg/s Diameter of the pipe, d = 80…

Q: A Poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample…

A: Given data: Length of tube; L=100 cm=1 mInternal Diameter; D=1 mm =0.001 mRadius; R=0.0005 mP1=865…

Q: Please solve all the choices with explanation

A: 1) by definition2) Reynolds number is given by μρ∗v∗D​ where rho = density of water = 1000kg/m3. v =…