Q11. One end O of a spring of mass m is fixed to a wall and the other end A is free. The spring rests on a frictionless horizontal surface. The free end A is pulled to the right by a distance 'a' then released. Then the speed of the end A when the spring has acquired its natural length is

Q11. One end O of a spring of mass m is fixed to a wall and the other end A is free. The spring rests on a frictionless horizontal surface. The free end A is pulled to the right by a distance 'a' then released. Then the speed of the end A when the spring has acquired its natural length is

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

9. A block with a mass of 1.9 kg is held against a spring constant 249N/m. The block compresses the spring 21 cm from its equilibrium position. After the block is released, it travels along a frictionless surface and then up a frictionless ramp. The ramp's angle of inclination is 28° a. Determine the elastic potential energy stored in the spring before the mass is released. b. Calculate the speed of the block as it travels along the horizontal surface. Determine how far along the ramp the block will travel before it stop. 28°
sA spring with a constant k = 100 N/m is placed after point-C in the frictionless ABC path. A ball of mass of 2 kg is initially at rest and released from point A. The ball travels through the ABC path and finally hits the spring. a) What is the velocity of the ball at point B and C? b) What is the maximum compression in the spring?
1) A box of mass m= 50kg which is sliding on a horizontal rough surface and momentarily comes to stop after compressing the spring by a distance of 120 mm. The spring has a spring constant k = 20KN/m and is initially in its equilibrium state. The initial speed of the box is 3.0m/s. a) What is the work done by the spring as the box is brought to a stop? b) Write an expression for the work done by friction during the stopping of the box (in terms of the coefficient of kinetic friction). c) Determine the coefficient of friction between the box and the surface. v=3.0 ms 600 mm 600 mm 120 mm-
Computation. A custom-designed spring has a restoring force F(x) = − (ax + Bx²) where x is the stretch from its equilibrium length, a = 3.4 N/m, and 6 = 4 N/m². A 4-kg gizmo is attached to this spring and stretched 1.7 m over a frictionless, horizontal surface. If the gizmo is released from rest, how fast will it be moving when it passes as its equilibrium position? V= Record your numerical answer below, assuming three significant figures. Remember to include a "-" if necessary. OL m/s C 10:25 PM 10/23/2022 2
A spring is compressed 8.00cm to launch a 35.0g ball horizontally along a frictionless tabletop. The ball rolls off the edge of the table and falls 1.60m to the floor where it hits the floor with a speed of 19.0m/s. What is the spring constant of the spring?. Single line text.
:) A spring with a constant k = 100 N/m is placed after point-C in the frictionless ABC path. A ball of mass of 2 kg is initially at rest and released from point A. The ball travels through the ABC path and finally hits the spring. a) What is the velocity of the ball at point B and C? b) What is the maximum compression in the spring? 22 kg 1.8 m 0.45 m g=9.8 m/s?
A spring with k= 360 N/m is compressed x = 11cm by a 1.85 kg block on a horizontal table with coefficient of friction of 0.38. This means there is friction everywhere on the table! A. What is the speed of the block when it is released? B. Determine the distance the block travels before it comes to rest.
A box with mass of 150 kg is released from point A, 43 meters above the ground. The box slides without friction and then collides with a massless spring that is initially uncompressed. a) What is the total energy of the system? b) What is the speed of the box right before colliding with the spring? After colliding with the spring, the box gets stuck to the spring and starts oscillating back and forth. c) If the spring constant is 300 N/m, what is the amplitude of oscillation for the box-spring system? d) When the spring is compressed by Δs = 1.5 m, find the speed of the box. e) Find the maximum acceleration experienced by the box. f) What is the period of oscillation?
A spring with a constant k=100 N/m is placed after point-C in the frictionless ABC path. A ball of mass of 2 kg is initially at rest and released from point A. The ball travels through the ABC path and finally hits the spring. What is the velocity of the ball at point B and C?. What is the maximum compression in he spring? (9.8 m/s^2)
wwwwww Xmin .xmax 9 A block connected on a spring oscillates back and forth on a frictionless horizontal surface reaching the minimum and maximum distances min and max, respectively. Which of the following graphs best represent the kinetic energy of the block as a function of the length x? JUJALA ILI X Xmax (A) min Xmax (B) Xmin Xmax Xmax (C) Xmin (D) Xmin B OC OA OD
Suppose a pendulum starts with a potential energy of 100 J. Assuming the pendulum has a height of 0 m at the bottom of its swing, what is its maximum kinetic energy? Explain.
A) Calculate the work done by friction as the block slides down the incline. B) Find the speed of the block when it just reaches the spring. C) What is the spring constant, if the block compresses the spring by a distance of0.10 m? D) On the return trip, what maximum height will the block achieve beforemomentarily coming to rest and returning back down the incline? E)Find the compressed distance of the spring the second time it iscompressed.