Q11/ Figure below shows a typical microwave receiver used in satellite communication. Calculate: i) ii) The overall noise figure of the receiver. The overall equivalent temperature of the receiver. Assume that the ambient temperature T = 17°C. Y Te-5'K Master Amp. G1-30dB or (1000) F2=5dB or(4) TWT G2-20dB or (100) (ans. F=1.02=0.08766dB) (ans. Te=5.8°K) F3-12dB or(16) Mixer and IF Amp. G3=40dB or (10000)

Q: Subject name: Signal processing measurement Question: Is there any difference between the metallic…

A: Resistance is the property of opposition to the flow of current and is the important property of…

Q: . Draw the d.c load line for the circuit diagram shown below. What will be the Q point if zero…

A: Redrawing the above circuit with proper markings: To draw the DC load line of the PNP Transistor we…

Q: What do you think is the main disadvantage of a Clipper circuit over a Clamper Circuit?

A: The disadvantage of a Clipper circuit over a Clamper Circuit can be explained as follows.

Q: The nameplate for the large transformer in the lab is shown below. This transformer supplies the…

A: 1. You want the secondary voltage to be close to 120/208 V, you can adjust the transformer tap…

Q: Dada la información que aparece en la imagen de abajo (circuito con transistor de configuración…

A:

Q: Explain the two types of MOSFETs (draw the physical structure as well). Also explain the major…

A:

Q: derive forirer components of square wave signal

A: The objective of this question is to derive the Fourier components of a square wave signal. The…

Q: Q1. The set of independent of voltages are recoded as :50.8, 50.5, 50.2, 50.1, 50.3,50.6. Calculate:…

A: We are authorized to answer only 1 question and only 3 subparts at a time since you have not…

Q: Draw and explain the working of any one balanced modulator circuit

A: Introduction Modulator circuit: For the purpose of wireless transmission, a modulator is an…

Q: XProblem No.1 (P). A fixed bias NPN BJT (Beta = 90) circuit is connected to a 16VDC supply with the…

A:

Q: II- Determine the Vautr from the reverence cold junction LM335 if the temperature of the environment…

A: cold junction with LM335 Temperature T=20°C=293 K It is given that VoutToTo=10 mV/K…

Q: 1. The following questions refer to the circuit shown below. a) What do the areas of the circuit…

A: Here in the given circuit which is  labeled as  'A' is an optocoupler circuit consisting of a light…

Q: Describe the pins that are utilised in the maximum and lowest modes.

A: The microprocessor or microcontrollers have different types of PIN configuration and physical…

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.