Q10. As shown in the image below, a block is being lifted using the cable and pulley system. (The cable and pulley system is friction-less and weight-less.) The ends of the cables are fixed at the center of each pulley at A, B and C, and overall there are 3 continuous cables. Determine the speed (magnitude of the velocity) of the block if v = 7.7 m/s -- vis the speed of the end of cable being pulled down. Please pay attention: the numbers may change since they are randomized. Your answer must includj 3 places after tjhe decimal point, and proper Sl unit.

Q10. As shown in the image below, a block is being lifted using the cable and pulley system. (The cable and pulley system is friction-less and weight-less.) The ends of the cables are fixed at the center of each pulley at A, B and C, and overall there are 3 continuous cables. Determine the speed (magnitude of the velocity) of the block if v = 7.7 m/s -- vis the speed of the end of cable being pulled down. Please pay attention: the numbers may change since they are randomized. Your answer must includj 3 places after tjhe decimal point, and proper Sl unit.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

I am attaching both questions for 4 and 5 with the question in the image. thank you. NOTE : So the last person answered this question WITHOUT refencing the answer for whether question 4 or 5 answeres were given, so i am asking for question 5(or the answer for the question that was NOT solved because it was not referenced.) These were the following answers given to me from the last person on bartleby who answered my question without referencing whether it was the answer for question 4 or 5. 1 pass 2 fail 3 fail 4 pass
That is the answer I already have, I am lookinf for the answers to the blanks in the image
Topic/s: Force System of a Force, Moment of a Force, Moment of a Force-Scalar Formulation,Moment of a Force-Vector Formulation, and Principle of Moment. Reminder: Kindly show the complete step-by-step solution. Please make sure that your handwriting is understandable and the picture of the solution is clear. I will rate you with “like/upvote” after. Thank you.
Please do this carefully.
It's saying this is not correct. Thank you for your help.
An electric hot water heater consumes 3.1 kilowatts of electricity and converts it to heat. How long will it take the water heater to heat a 67 gallon tank of water from 10 degrees Celsius to 50 degrees Celsius? (1 kilogram of water is 0.37 gallons, 1 Calorie = 4200 J). It may be helpful to refer back to the weekly handout for guidance on this problem. Your final answer should be in minutes (rounded to the nearest 10 minutes).
Please walk me to find the answer and please include the magnitude of the force.
The attached answer was provided for the attached question. The equation uses the given temperature in celcius and the answer is also given in celcius. The temperature was used in the equation without converting from F and the answer was supposed to be in F. I am worried that even if I converted the answer to celcius that it would be correct because temperature was used in the equation using the incorrect unit.
can you provide an answer easie to read. the answer is put into sentences like fcv=mgcos 6
Please ANSWER ALL of the given questions. I will rate you with “UPVOTE/LIKE” if you answer every question. I will rate you with “DOWNVOTE/DISLIKE”, if you don’t answer every question. THANK YOU.
I need help with the second table. and these questions 1- If 1 gallon of oil = 1.4 therm, how many gallons have been wasted by heat loss in Feb? (1 therm = 100,000 BTU) 2- If $1.30 per therm, how much did you waste from house heat loss in Feb?
Answer question four please.