Q1. A non-periodic composite signal containsfrequencies from 15 to 50 KHz. The peakamplitude is 20 V for the lowest and the highestsignals and is 40 V for the 30-KHz signal.What is a non-periodic compositea.signal?b. What is the bandwidth of this signal?c. Assuming that the amplitudes changegradually from the minimum to themaximum and then maximum to theminimumdrawthe frequencyspectrum.

The Answer is in given below steps

Q1. A non-periodic composite signal contains frequencies from 15 to 50 KHz. The peak amplitude is 20 V for the lowest and the highest signals and is 40 V for the 30-KHz signal. a. What is a non-periodic composite signal? b. What is the bandwidth of this signal? c. Assuming that the amplitudes change gradually from the minimum to the maximum and then maximum to the minimum draw the frequency spectrum.

Q1. A non-periodic composite signal contains frequencies from 15 to 50 KHz. The peak amplitude is 20 V for the lowest and the highest signals and is 40 V for the 30-KHz signal. a. What is a non-periodic composite signal? b. What is the bandwidth of this signal? c. Assuming that the amplitudes change gradually from the minimum to the maximum and then maximum to the minimum draw the frequency spectrum.

Computer Networking: A Top-Down Approach (7th Edition)

7th Edition

ISBN:9780133594140

Author:James Kurose, Keith Ross

Publisher:James Kurose, Keith Ross

Chapter1: Computer Networks And The Internet

Section: Chapter Questions

Problem R1RQ: What is the difference between a host and an end system? List several different types of end...

See similar textbooks

Related questions

Q: Find the convolution of the following two signals: (a) x₁(t) = u(t) - u(t - 1); (b) x₂(t) =…

Q: a) The signal x(t) is shown in the following plot. x(t) 3

Q: Find the convolution of the (a) x(t) = e²tu(-t); (b) h(t) = u(t-3).

A: the answer is given below :

Q: Transfer function is the ratio of Laplace transform of input to Laplace transform of output under…

A: answer to the above choice question is in step2.

Q: 8. For the network in Fig. 7.71 O: a. Determine R7. b. Find /, , and 2. c. Find voltage V, R3 10 Ω…

A: ANSWER:-

Q: Write a function file that takes a domain vector t, a scalar amplitude A, and a scalar period T as…

A: The answer is an given below :

Q: As an OCTAVE pogram: A 1 kg mass is rests on a frictionless 1 meter long ramp and compresses a k =…

A: Source Code: clcclear allclose allk = 4000 ;%stiffness x = 5/100 ; %spring displacmentm=1 ; %mass…

Q: Each of three members of a congress is equipped with a push button; the button is pressed if the…

A: The Answer for the above given question is given below:

Q: (a) An aperiodic signal is defined as x(t) = sin(at) u(t), where u(t) is the continuous time step…

A: Question:

Q: a) The signal x(t) is shown in the following plot. x(t) 3

Q: 3.

A: Given 1 2 g(t) is a signal derived from x(t) as shown in the following plot — —1 0 1 2 3 Write an…

Q: (a) x₁(t) = u(t)- u(t-1); (b) x₂(t) = u(t-1)-u(t-2).

A: the answer is an given below :

Q: 8. Consider transmitting a digital data: 10111000101. Draw the signal representation when a. Using…

Q: A radio system transmits a 2.4GHz signal at 250mW over a distance of 20m through two antennae with a…

A: Answer is given below

Q: The current and voltage across a circuit element are given by the equations I(t) = 20e 100t (mA),…

A: Code: I = @(t) 20*exp(-100*t); V = @(t) 10-5*exp(-100*t); P = @(t) I(t).*V(t);…

Question

Q1. A non-periodic composite signal contains
frequencies from 15 to 50 KHz. The peak
amplitude is 20 V for the lowest and the highest
signals and is 40 V for the 30-KHz signal.
What is a non-periodic composite
a.
signal?
b. What is the bandwidth of this signal?
c. Assuming that the amplitudes change
gradually from the minimum to the
maximum and then maximum to the
minimum
draw
the frequency
spectrum.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

For the function, F(x, y, z) = (x+z)'+(y'z)+(xz)' find its complement. Select one: 1. (xz)' II. (x + y)' III. (xz')' IV. (x' + y + z')' V. xyz O IV. V Oll 01 OIV
Unless specified otherwise, use the free space propagation speed of light 3x108 m/s to calculate the propagation delay. For numerical calculations, the results must show the appropriate unit. Show a complete solution for each problem4. A digital audio broadcast service is used to transmit digital music. Stereo audio signals are to be transmitted using a digital modem over a data link. A stereo signal uses two channels. In each channel, an audio signal is sampled at a rate of 44 kilo samples/second and quantised using a 24-bit quantiser. The data link has a transmission bandwidth of 0.5 MHz. Assume a 46-byte overhead is added to each packet before transmission.a. What is the total bit rate produced by a stereo audio signal?b. What is the minimum SNR value (in dB) required for the above data link?c. Assume that the broadcast service uses the UDP/IP/Ethernet protocol to transmit digital audio, using a packet switched network. The maximum packet size is limited to 800 bytes, which includes…
Given is a sine wave in time domain, using this wave plots answer the following: 1 second ww. Time A- How much is the wave amplitude with its unit? Answer B- How much is the wave frequency with its unit? Answer C- Draw the same wave in the frequency domain Answer
A signal's spectrum contains four components: -2500 Hz, -1700 Hz, +1700 Hz, and +2500 Hz. If we assume this spectrum is the product of two sinusoidal signals, what are the frequencies of the two signals whose product gives rise to this spectrum? 400 Hz and 2100 Hz 1700 Hz and 2500 Hz 1300 Hz and 2100 Hz 800 Hz and 4200 Hz
Implement the following function with a8-to-1-line Multiplexer with threeselection lines? Draw the truth table and the corresponding block diagram for the MUX?F(A, B, C, D) = Σm ( 1, 3, 4, 11, 12, 13,14,15 )
please help. here is my code but my professor said" it was not intended to start with the sinc function to generate the plots. Should define the rectangular pulse in the time domain and then perform the fft on that." Please fix my code: close all; clear; % Frequency range and increment for graph f = -0.3:0.001:0.3; % Establishing values for Tau and Fourier Transform functions T1 = 5; x1 = pi * f * T1; M1 = (T1 * sin(x1)) ./ x1; T2 = 10; x2 = pi * f * T2; M2 = (T2 * sin(x2)) ./ x2; T3 = 25; x3 = pi * f * T3; M3 = (T3 * sin(x3)) ./ x3; M1(isnan(M1)) = T1; M2(isnan(M2)) = T2; M3(isnan(M3)) = T3; % Perform FFT and FFT shift for each signal F1 = fftshift(fft(M1)); F2 = fftshift(fft(M2)); F3 = fftshift(fft(M3)); % Plot magnitude of the signals figure(1) plot(f, abs(M1), 'c', f, abs(M2), 'b', f, abs(M3), 'm'); xlabel('Frequency (Hz)'); ylabel('|x(f)|'); title('Magnitude Plot of Fourier Transform of…
2. Identify the Idempotent Law for AND and OR. AND: xx¹ = 0 and OR: x + x = 1 AND: xy = yx and OR: x + y = y + x AND: xx = x and OR: x + x = X AND: 1x = x and OR: 0 + X = X
The Kmap for a Boolena function is given. yz WX 00 01 11 10 001101 01 110 1 110000 10 1 1 1 1 1. Write a simplified expression of the function F(w,x,y,z) 2. Write the complement of the simplified expression of function F(w,x,y,z) 3. Write the sum-of-product form of the function F(w,x,y,z) 4. Write the product-of-sum form of the function F(w,x,y,z)