Q1) Water flows through a vertical contraction (venturi) section. Piezometers are attached to the upstream pipe and minimum area section as shown. The velocity in the pipe is V= 1 m/s. The difference in elevation between the two water levels in the piezometers is d = 10 cm. What is the velocity (m/s) at the minimum area? V

Q1) Water flows through a vertical contraction (venturi) section. Piezometers are attached to the upstream pipe and minimum area section as shown. The velocity in the pipe is V= 1 m/s. The difference in elevation between the two water levels in the piezometers is d = 10 cm. What is the velocity (m/s) at the minimum area? V

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

PROBLEM 2 The pressures at polnts 1 and 2 of the water plpe shown are 300 kPa and 100 kPa, respectively. If the velocity at section 1 is 20 m/s and water flows steadily, determine (a) flow rate (m/s) and the (b) diameter (cm) of the plpe at section 2. 50 m d, =0.1 m Elevation View
Q3) A differential manometer is connected at two points A and B of two pipes. The pressure at A and B are 1 bar and 2 bar respectively. Find the difference in mercury level in the diffrential manometer. Sp. gr= 1.5 Sp. gr.=0.9 2.0 m
8.4
PROBLEM 4 A pipe has a total length of 9800 ft with diameter of 30 in., and its thickness is 5/8 in. Assume that Ep = 30 x 10° psi, and Es = 300,000 psi. If the initial velocity for steady flow is 8 ft/s and a valve near the end of the pipe is partially closed so as to reduce the flow to half of the initial velocity in 3 seconds, (a) What is the wave celerity (ft/s), and (b) find the maximum pressure rise (psi) from the water hammer.
Q1(b) Water flows through a pipe with a diameter of 2 m. Stagnation and static pressures measured by pitot tube are 0.3 m and 0.25 m of water, respectively. Calculate the velocity of flow
Air at 30°C flows through a 70 m long, 2 cm x 2 cm rectangular cross section pipe as shown in Figure 1(b). The flow is laminar flow and centerline velocity is 2 m/s. If the angle of pipe measure from horizontal plane is 35º, determine : (iv) wall shear stress; (v) shear stress at 1 cm from the center of the pipe; and (vi) power required to maintain this flow.
Question 3 Water is flowing in a rigid pipe, the pressure wave travel will velocity (c) 950m/s. The value of compressibility of fluid is 6×10-10 m² N Assume velocity of water V = 4m/s. . The value of water hammer pressure will be:
Q.2 For h 1 m in the setup shown in figure find: 1. Pressure head at point a 2. Seepage velocity 3. Find h if the force on screen b is 2.5 kN/m² WIT 1.0m -0.25m Screen b h W.T 41 n=1/3! @ K=0.5 cm/sec. Datum 84=21kN/m³ Cross-Sectional area of the tube=0.5m² -
A drain pipe exits a reservoir as shown. What is the pressure head at point 2?