Q1) The solid phase of a point (in the two-phase region) in the Bi-Sb alloy contains 80 at% of Sb. The fraction of the liquid phase of this point is approximately 0.27. From the figure, find the following information of this point: 650 630.6 °C 1- The temperature. 2- The overall alloy composition (C.). 3- The composition of the liquid phase. 4- The fraction of the solid phase. 600 550 Liquid O 500 450 400 350 300 271.4 °C 250 200 10 20 30 40 50 60 70 80 90 10 Atomic percent Sb Bi Sb Temperature (°C)

Q1) The solid phase of a point (in the two-phase region) in the Bi-Sb alloy contains 80 at% of Sb. The fraction of the liquid phase of this point is approximately 0.27. From the figure, find the following information of this point: 650 630.6 °C 1- The temperature. 2- The overall alloy composition (C.). 3- The composition of the liquid phase. 4- The fraction of the solid phase. 600 550 Liquid O 500 450 400 350 300 271.4 °C 250 200 10 20 30 40 50 60 70 80 90 10 Atomic percent Sb Bi Sb Temperature (°C)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Question 9 What is the location of FR, i.e., the distance d? A MB 3 m 3 m & Moving to another question will save this response. R B
What is the normal force applied to the block?
d C b ta ➤
answer?
show work and diagrams
1+1? This is a free question
Enumerate the steps taken in creating the objects.
4. MM 3omm 50 30 mm
19) During the Vicker harness experiment, it is found that the diameter of indenter is larger than indentation diameter. Select one: True False
(b) A plastic rod AB of length L = 510 mm has a diameter d, = 30 mm as shown in Figure Q2(b). A plastic sleeve CD of length c = 300 mm and outer diameter d2 = 45 mm is securely bonded to the rod so that no slippage can occur between the rod and the sleeve. The rod is made of an acrylic with modulus of elasticity E1 = 3.1GPA and the sleeve is made of a polyamide with E2 = 2.5GP . (i) Calculate the elongation & of the rod when it is pulled by axial forces P=15KN . (ii) If the sleeve is extended for the full length of the rod, what is the elongation? (iii) If the sleeve is removed, what is the elongation?
A+A-B+B- means O a. Cylinder A retracts and expands then Cylinder B expands and retracts O b. Cylinder A expands and retracts then Cylinder B retracts and expands O C. Cylinder A expands and retracts then Cylinder B expands and retracts o d. Cylinder B expands and retracts then Cylinder A expands and retracts
If a critical point at structural element is subjected to the stress shown on the 2D element, determine the factor of safety (FS) against yielding according to the maximum energy of distortion theory. The material has a tensile yielding stress Sy = 800 Mpa. 150 Mpa 50 Mpa 250 Mpa TOSHIBA