Q1: Mass flow through a sonic nozzle is a function of gas pressure and temperature(Pressure = P, Temperature = T). If the mass flow rate through the nozzle is given by:Pm = 0.0430;Where: m Ib/min, P = Psia, T= "RTO.5a) Determine what the units for the constant 0.0430 are?b) What will be the new value of the constant, now gives as 0.0430, if the variables in theequation are to be substituted with SI units and m is cakulated in SI units?

GIVEN: mass flow rate through the nozzle m =0.430pT0.5 here m = mass flow Ib/ min P = pressure…

Q1: Mass flow through a sonic nozzle is a function of gas pressure and temperature (Pressure = P, Temperature = T). If the mass flow rate through the nozzle is given by: m = 0.0430 0 Where: m lb/min, P Psia, T "R a) Determine what the units for the constant 0.0430 are? b) What will be the new value of the constant, now gives as 0.0430, if the variables in the equation are to be substituted with SI units and m is calculated in SI units?

Q1: Mass flow through a sonic nozzle is a function of gas pressure and temperature (Pressure = P, Temperature = T). If the mass flow rate through the nozzle is given by: m = 0.0430 0 Where: m lb/min, P Psia, T "R a) Determine what the units for the constant 0.0430 are? b) What will be the new value of the constant, now gives as 0.0430, if the variables in the equation are to be substituted with SI units and m is calculated in SI units?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The Ekman number, Ek, arises in geophysical fluid dynamics. It is dimensionless parameter combining seawater density ρ, a characteristic length L, Seawater viscosity μ, and the Coriolis frequency Ωsinφ, where Ω is the rotation rate of the earth and φ is the latitude angle. Determine the correct form of Ek if the viscosity is in the numerator.
Still think that unit conversion isn't important? Here is a widely publicized, true story about how failing to convert units resulted in a huge loss. In 1998, the Mars Climate Orbiter probe crashed into the surface of Mars, instead of entering orbit. The resulting inguiry revealed that NASA navigators had been making minor course corrections in SI units, whereas the software written by the probe's makers implicitly used British units. In the United States, most scientists use Sl units, whereas most engineers use the British, or Imperial, system of units. (Interestingly, British units are not used in Britain.) For these two groups to be able to communicate to one another, unit conversions are necessary. The unit of force in the SI system is the newton (N), which is defined in terms of basic Sl units as 1 N=1 kg · m/s?. The unit of force in the British system is the pound (lb), which is defined in terms of the slug (British unit of mass), foot (ft), and second (s) as 1 lb =1 slug ·…
An airplane passenger has a volume V1 of air in his stomach just before the plane takes off from a sea-level airport. a. What volume will this quantity of air have at cruising altitude at the same temperature (body temperature), in terms of V1, the pressure on the ground P1, and the cabin pressure at cruising altitude P2? b. What is this volume, in cubic centimeters, if the initial volume is 95 cm3 and the cabin pressure drops to 7.50 × 104 Pa when the plane is at cruising altitude?
The Statue of Liberty in New York City is approximately 305 ft305 ft tall. How many U.S. dimes would be in a stack of the same height? Each dime is 1.35 mm1.35 mm thick. number of dimes: Each dime has a mass of 2.268 g.2.268 g. How much would the stack of dimes from the previous question weigh? mass: g What is the value, in dollars, of the same stack of dimes? value: dollars The 2017 U.S. gross domestic product (GDP) was valued at 19,390,604,000 dollars.19,390,604,000 dollars. How many Statue of Liberty‑height stacks of dimes are needed to match the GDP in value? number of stacks:
Variation of Pressure in the atmosphere. The pressure of the atmosphere decreases as we move higher in the atmosphere. The decrease in pressure is proportional to the decrease in density of air. р = 2|2° P P Where P = pressure at any point in the atmosphere, and p = density of air at any point in the atmosphere Po pressure at sea level = 1.013 x 105 Pa, and Po air density at sea level = 1.3 kg/m³. a) What is the density p in terms of po, P, and Po? b) Start from the formula dP = - p g dy to determine the pressure at any height y. Note: P is variable c) What is the pressure if the height is 5.0 km above sea level? d) At what height above sea level is the pressure equal to ½ Po ?
Two cylindrical cross section water tanks are arranged so that the outflow from tank 1 falls into tank 2. The outflow from tank 2 flows to the drain. ģ is the volumetric flow rate out of a tank, and h is the height of the water in a tank. (a) State the fundamental physical law, and provide the general equation for a tank used to model the time history of the tank levels, h, and hz. Your equation should contain the following terms: A (eross sectional area of a water tank), p (density of water), and h (rate of change of the height of the water in a tank) (b) Both outflows have the characteristic volumetric flow rate being directly proportional to the head in the tank. ie. ġ1 = a, h, and q2 = azh2. Show that the differential equation governing the head in tank 2 has the form of : h, + ah, = be" Time, t, is the independent variable. Take the initial values of the heads to be A h(0) = H, and h,(0)= H,. Determine a, b and c. (Note: There is no d, or hi in the equation governing tank 2. You…
Q1. In trying to measure the mass of the cube, imagine that you had forgotten to tare the balance before placing the cube on the balance. What effect would this have on the calculated density of the cube, using the caliper method? Explain. Be specific when describing the effects; do not just say that the “results would be off” or the “results would be inaccurate”.
A piece of metal is placed in an empty sample bottle. The mass of the bottle + metal is 43.64g. With the metal left inside, the bottle is filled to capacity with water. The combined mass of the bottle, metal, and water is 61.44g. Assuming that the density of the water is 0.9976g/cm^3 A. calculate the mass of the metal B. Calculate the mass of water C. Calculate the volume of water D. Calculate the volume of the metal piece E. Calculate the density of the metal piece
Express the answer in standard scientific notation with the appropriate number of significant figures. a. The mass of a blue whale, 180000 kg. ____ x10 ^___kg b. The diameter of a helium nucleus, 0.000 000 000 000 003 8 m. ____ x10 ^___m
1:53 1.10 The pressure rise Ap associated with wind hitting a win- dow of a building can be estimated using the formula Ap = p(V²/2), where p is density of air and V is the speed of the wind. Apply the grid method to calculate pressure rise for p = 1.2 kg/m³ and V = 60 mph. a. Express your answer in pascals. b. Express your answer in pounds-force per square inch (psi). c. Express your answer in inches of water column (in-H,O).