Q1: Answer by True or False. 1- The pressure diagram can be used to calculate the hydrostatic force which applied on gate. 2- Shear stress do not exist when the fluid is at rest or moving with a uniform velocity. 3- P = yh For any liquid. 4- Any rise in temperature will lower the viscosity of liquids. 5- Orifice is used to measure the flow in tanks.

Q: A hydraulic cylinder has these specs: Bore: 3.5" Stroke: 20" Rod diameter: 1.25" Pressure: 1800 PSI…

A: Given:D=3.5 inL=20 ind=1.25 inP=1800 psiFlow rate=4 GPM NOTE: According to Bartleyby's policy we…

Q: describe the five types of reservoirs and draw pressure-temperature phase diagram of each fluid

A: Types of Reservoirs : Single phase gas reservoir: It primary consist of recovery mechanism of…

Q: The thermal mass flowmeter is used with Select one OaAll answers are wrong b. Gas and liquid…

A:

Q: SI unit of dynamic viscosity is a. Stokes b. Poise c. m2/s d. Ns/m

A: The measure of the fluid resistance to the flow is called viscosity. The measures of fluid viscosity…

Q: What is the horsepower of the pump? 1 -10⁰ Area = 1 =qift so' hf thm - zcas

A:

Q: What is high pressure pump?

A: High-pressure pumps generate a very high pressure of fluid supply. Generally, high-pressure pumps…

Q: Q3: Each cord can sustain a maximum tension of 500 N, Determine the largest mass (m) of p pipe that…

A:

Q: How to calculate the flow area of a half inch elbow at 90 degrees?

A: Solution: Given Data: D=1/2 in   To Find: Flow Area

Q: What is an impact when a float moves up into the tapered vertical tube of rotameter? O a. The…

A: Rotameter is a device used for the purpose of flow measurement. In this device a float is used to…

Q: What volume of oil to the cylinder is required to cause the cylinder to advance at a speed of 392…

A: Given Data: The speed of advance of the cylinder is, C=392 in/min. The diameter of the piston is,…

Q: The turbine depends mainly on the fluid kinetic energy to produce power

A: This question is based on the concept of turbine .

Q: What must the water pressure need to be on for the third floor sink (36ft off the ground) to have…

A: Given data,  H= 36 ft =10.9728 m. Pressure at third floor  P=32 lbf/in2 =220632 Pa.   Let density of…

Q: On what condition will there be no cavitation in the pump? When NPSHavailable = NPSH required When…

A: ● Introduction to NPSH: NPSH (Net Positive Suction Head) is the minimum head required at the suction…

Q: I need these three parts answered pertaining to the print provided. If you can not answer all three…

A: The term, Orthogonal, describes the relationship of the axis of the ½” NPT pipe plug with the main…

Q: The rest of the questions are thus: 4) Calculate the air temperature and pressure in the pump at…

A: Given R=287 J/kg.k= 0.287KJkg.k Cp=1.005KJkg.k y=1.4 P1= 1 bar= 100 kPa T1=298 K   Explanation:…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.