(Q1) A constant volume vessel of 1.115 m3 has a refrigerant R134a of total mass of ten kg at temperature of (-30 C). After heat energy is added to the system, the pressure of the working fluid became 200 kPa. Find final temperature and initial pressure of the system.

(Q1) A constant volume vessel of 1.115 m3 has a refrigerant R134a of total mass of ten kg at temperature of (-30 C). After heat energy is added to the system, the pressure of the working fluid became 200 kPa. Find final temperature and initial pressure of the system.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

7. For an Ideal Gas, find the Partial Derivative of v, w.r.t. P. 8. Please consider large room that needs a new carpet. The vendor came and estimated the cost at $8 to $12 per square foot, depending on the condition of the sub-floor. The vendor then "paced off" the room and estimated that the room was 60° by 50’. You estimated that the vendor's method of measuring the room dimensions could be off by as much as 3' in for each dimension. Please find the (a) mean cost, (b) best case cost, (c) worst case cost, and (d) the most probable cost,
Using the tables for water, determine the specified property data at the indicated states. (a) At p = 3 bar, v = 0.2 m³/kg, find T in °C and u in kJ/kg. (b) At T = 320ºC, v = 0.03 m³/kg, find p in MPa and u in kJ/kg. (c) At p 28 MPa, T = 600°C, find v in m³/kg and h in kJ/kg. (d) At T=10°C, v = 10 m³/kg, find pin kPa and h in kJ/kg.
Please don't provide handwritten solution ....
The gas A(g) (1 mole) undergoes a two-step process one after another as described below :i) The gas is expanded at 25°C and from 1 bar pressure against a constant pressure of 0.2 bar and the final volume of the gas is the twice the initial volume.ii) The gas is cooled down to -25°C at constant volume.Cv,m = 3/2 RCalculate ΔU, ΔH, q and w for the each step and for the entire process
Q1) A constant volume tank contain 1 mole ofC7H14and 12 mole of O2 gas at a temperature of 25 °C and 1 bar. The contents of the tank is ignited and C7H14 is burned completely and final products temperature is found to be 1700 K. Determine the heat transfer during this process. ( take daltaHo = -47800 kJ/kg).
need help! will rate if completed ! assume perfect gas behavior
A 0.2m3 rigid tank initially contains pure oxygen gas (02) at 20°C and 1000 kPa. The tank containing the oxygen is put on a scale to measure its mass. The initial mass is recorded as 110.4 kg. Nitrogen gas is injected isothermally into the tank until the scale reads 121.0 kg. The molar mass of oxygen is 32kg/kmol and the molar mass of nitrogen is 28 kg/kmol. Assuming that the gases behave ideally, answer the following questions: a) What is the mass of the empty tank? b) What is the composition of the final mixture on a mole basis? c) What is the final pressure of the tank? d) The critical temperature and pressure of oxygen are 154.6K and 49.8atm. Based on these properties, comment on the appropriateness of using the ideal gas law in part a)
I need the answer as soon as possible
1 (av (2) Calculate thermal expansion coefficient a = and isothermal compressibility K = ат 1 -÷) for the following gases: v (ap, T (a) Ideal gas (1 mol), pV = RT (b) Van der Waals gas (1 mol), (p +2) (V – b) = RT (c) Non-ideal gas (1 mol), pV = RT (1-B(T)) (B is called second virial coefficient)
Qui Air in a closed piston-cylinder arrangement is expanded from the initial pressure of 8.3 bar and initial volume of O.029 m to the final state of p2 2.2 bar. A polytropic relation of pV13 = constant was followed between pressure and volume for the process. The specific internal energy at the initial and final states are 156.5 and 101.5 kJ/kg, respectively. The mass of the air is 0.28 kg. Neglecting the effect of kinetic and potential energy, determine the heat transfer, inkJ.
Find AS (cal/K) when 6.4 mol of some gas O2 is heated from 1.2 K to 2.4 K with P held fixed at 1.00 atm. Where Cpm=a+bT,where value of a=9.46 cal.mol1K1 and b=0.00135 cal.mol1K2. Answer: