Q.4. Compute the design shear strength of the beam cross section shown in the below figure with the shear reinforcement #3 U shaped stirrups@ 8-inch c/c. Take fc-4000psi, and fy=60,000 psi 2#4 #3 stirrups @8 in. h (inch) 4#9 b (inch) J 3 in. b(inch) 18 h (inch) 32

Q: A wide flange A60 steel column has a length of 5.8meters and pinned ends. If Sx=857x103 mm3,…

A: The following are the given information. A=7243 mm2 Fy=414 MPa Sx=857×103 mm3 Sy=135×103 mm3 d=358…

Q: Part B Determine the force in member CJ and state if this member is in tension or compression.…

A:

Q: strain in the tension bars equal to  0.004 and  in the design process use 60% of this rho max.…

A: Given : DL = 10 kN/m LL = 8 kN/m UDL & 15 kN/m UVL 8 m length fc = 21 MPa and fy = 276 MPa

Q: The continuous beam and post system shown below supports a 10 kip vertical load and a 5 kip…

A: The moment and shear force will act at point B. Moment and shear will be caused due to force of 5…

Q: A solid circular shaft of diameter d and length L is fixed at one end and free at the other end. A…

A: Given a solid circular shaft with, Diameter d. Length L is fixed at one end and free at another end.…

Q: Deflection Given: the beam cross-section shown have the following cross-sectional properties  f'c…

A: Gross moment of inertia(Ig)Critical internal moment(Mcr)Maximum service load(Ma)Critical moment of…

Q: Figure Part A P= A Value 26₁ +26+21= ft If the beam is made from wood having an allowable shear…

A: We have to find the maximum value of P

Q: 1. For each of the following, assume a rectangular cross section with tension steel only and…

A:

Q: Per missible As in section to ensure tensile Compute the design strength of beam shown if fy = 420…

A: To find : design strength

Q: Determine the forces in members BC and CG. The forces are positive if in tension, negative if in…

A: Find out the forces in member BC and CG in given truss.

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.