Q.33: For the circuit shown in figure beside, if the supply 10sin2x10°t+5cos3x10°t mA, find the power absorbed by 2Q resistor? (Ans.: P20=1.72W) curent İ7=5+20sin10°t- iT is: µF 10μΗ

Q: For the circuit shown in the figure below, if V, =140 V (rms), f =50 Hz, and R =1.9 k2, and C =1240…

A:

Q: 330 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is…

A: In this question we need to find a addition of conducting and non - conducting period.

Q: ide al diode ffechive vulue frequency equeal to 6o He. the source is sinu soidal, with an e equal…

A: This is half wave Rectifier with RC filter.  If the ripple = 6.06%  The average output Voltage?

Q: Determine the peak and average voltage, current, and power delivered to R₁ in the figure below. Use…

A:

Q: QUESTION 2 a) Figure 3 shows some parts of a power supply circuit. Assume that the diodes D1- D4 are…

A: The solution is given below

Q: What is the peak output voltage during positive cycle? Use ideal diode Vit) Vm 0 -Vi 10 V T -10 M…

A: We need to find out the peak  value of output voltage.

Q: If V1 = 18 V, V2 = -9 V, R1 = 1.2 kOhm, R2 = 4.7 kOhm, R3 = 2.4 kOhm, and all V. diodes are silicon…

A: The solution is given below

Q: Assume all diodes are ideal unless otherwise stated. Question 3 V1 -5V 0.8 0.6 0.4 Perform load line…

A: Assuming all diodes are ideal. The V-I characteristics of diode is

Q: 20v 3K 本

A: Write the value of forward voltage drop across both types of diodes. vdsi=0.7 VvdGe=0.3 V

Q: 20 kL Q.7 lind the saturation curront I cand for the ligure bellow 2.4k2 5lo ke Ve B = 1o0 Ve E VE…

A: Given data: RC=2.4 kΩ RE=1.5 kΩ Solution: To operate the transistor in the saturation region,…

Q: 8. Draw the output waveform for the circuit shown below given Vin(pp)=20V. Write the name of the…

A: We need to find out the output voltage for given circuit

Q: JXM2 For the circuit shown if Vs=100°V: 42 J524 J62 1. Find the value of "XM" that makes the Vs…

A: The solution is given below

Q: Q1 For the op-amp circuit shown below V is approximately equal to 10 V 105 N 95 2 1 MN 100 kN 100 k2…

A:

Q: Sketch i0  and v01 for the network below for the input shown (Both diodes are Si. Vd = 0.7 V)…

A: During the positive half cycle only diode D1 is forward biased and it will conduct and with the help…

Q: •plot * Use ideal diede model D * plot Vout vs Vin Vin R Vout

A: Explanation: An ideal diode is a diode that acts like a really perfect conductor while voltage is…

Q: For the circuit shown below: R Vs assuming ideal diode Vs- 61 Vsintwt) V. R- 50 0 Find the RMS…

A: In this question we will find RMS value of load current... Note:- due to bartleby policy, I will…

Q: The value of α20 for copper is 0.00393, so find the value of α for 0 °C and for 50 °C.

A:

Q: +5 V +5 v 2.5 kN 3 2.5 kN 2.5 kN (a) (b) (c)

A:

Q: A diode has n = 1.06 at T = 320 K. What is the value of n ·VT? What temperature would give the same…

A: Given data: n = 1.06 T = 320 K   The expression for the nVT is given as,…

Q: C 2.5 k. 2.5 kn -5 v -S V (c) +

A:

Q: T1 300 OA OV 120V(RMS) R1 60HZ D1 R2 5k 10:1 1N4004

A: In the positive half cycle, diode will be in the reversed bias, it behaves as an open circuit.…

Q: Assume that the diode D1 is ideal and D2 has cut-in voltage of 0.3 V as given in the circuit below.…

A:

Q: Ug = +loV A D1 R2-5k

A:

Q: Estimate thermal voltage for 30o C.

A: The thermal voltage (VT) is a very important quantity in semiconductor physics. It is dependent on…

Q: Aluminum has a resistivity of 10.6×108 Om at 20°C. What will the resistivity of Aluminum when then…

A:

Q: Find the Vout of the circuit below during the positive half cycle. V3 C1 10 Silicon R1 v1 Vout v2 50…

A: The nodes in electric circuits can be defined as the connecting point of different branches and…

Q: Q1: For the circuits shown in figures. If the temperature has changed from 25°C to 65°C, find Alc.…

A: First we will calculate for 25°C, α=β1+β=5556 Ic=βIB IE=IC+IBIC=αIE+ICOtherefore,IE=αIE+ICO+IB…

Q: Find the range of values that will keep the zener diode “on” (operating) in the figure. (Plot the…

A:

Q: Please answer in typing format

A: Step 1: Step 2: Step 3: Step 4:

Q: 7 V1 10Vrms 60Hz 0° R1 mw 1k0 D1 1N3493 R2 1k0 XSC1 fektonik

A: Diode: Diode is a two terminal device which condutcs only in one direction.  In second approximation…

Q: Find the current through the zener diode for the given values of load resistance

A: In this question,  A circuit is given with zener diode as shown in the figure.  Find the current…

Q: If the diode in Figure below shorts, the * voltage across RA will R1 1.4kQ RA 150 2 D3 Vs D6 2N3870…

A:

Q: diode whose internal resistance is 17 ohm is to supply power to a 2,008 ohm load from a 110V RMS…

A: In this question we will find dc load voltage in given half wave rectifier circuit....

Q: Sketch i0and v01 for the network below for the input shown (Both diodes are Si. VD=0.7 V). Explain…

A:

Q: I, II- Find the values of I and V in the circuits shown in Figure a and b, Assume V₂ = 0 Volt (ideal…

A:

Q: Given the figure below, discuss how the circuit recovers the original information from the input AM…

A:

Q: From the diode circuit shown in Figure 1, show how to determine the resulting output voltage signal.…

A: A diode is a two-terminal electronic component with a crucial property: it allows current to flow in…

Q: 420 ohm 30 V 1,(max) = 80 mA Voltage 0.6 V Vp-in 2.2 kohm Vp-out Zener Current Answer the following…

A: Given :    Izmax = 80 m A    RL = 2.2 K ohm    Rs = 0.42 K ohm    ILmin = 0 m A    We need to find…

Q: d) A regulator as shown in Figure 4 has an input voltage, Vs = 12 V. The duty cycle, k = 0.35 and…

A: Since there are multiple sub-parts uploaded within the same question, therefore solving first three…

Q: Determine zener diode boltahe value as well as the ripple percentage of the circuit bellow with…

A: Note: Since the rating of the Zener diode is not mentioned in the question, hence we can not find…

Q: Sketch i0and v01 for the network below for the input shown (Both diodes are Si. VD=0.7 V). Explain…

A: The both diodes will not conduct at all because if you do the open diode testing then for positive…

Q: +5 V +3 v +2 voD I kn +1 Vo A +3 Vo I kn +2 vo +1 v K (e) (f)

A: Silicon diode Ideal so Vd =0V

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.