Please answer in typing format Q9) A surface electrode can be modeled by the following circuit.Rs= 1k OhmRd= 10 OhmEhc= -0.2VCd= 30 pFEncCaWhat would the out put voltage be if 3 volts were applied at 100Hz?

Step 1: Step 2: Step 3: Step 4:

Answered: Q9) A surface electrode can be modeled…

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Similar questions

quick please
Nichrome ribbon resistor elements each has a resistance of 1 ohm. The element is made from sheet of nichrome alloy, 0.025 cm think. If the width of the ribbon is 0.3cm, what length is required per element in cm? Assume specific resistance of nichrome alloy to be 109microOhm-cm.
A-How temperature affects the conductivity of conductive metals and how it affects semiconductors.semiconductors B-What is superconductivity, how does it relate to temperature? Some examples of superconductors.superconductors.
The effective voltage of alternating current is __________ times its highest or peak voltage. Select one: A. .9 B. .707 C. 100% D. E=IXR
A silicon semiconductor has a shape of a rectangular bar with a cross sectional area of 1x10-6cm2 and a lenght of 0.1 cm. How do i calculate the current through the semiconductor if a basis of 5 volts is applied across its length?
Notes on the verification of ohm's law by voltage method?
How about solving this using KCL equations? Thank you
PROBLEM 2 Two semiconductor materials A and B shown in the given figure, are made by doping germanium crystal with arsenic and indium respectively. The two are joined end connected to a battery as shown in figure. Is the junction forward biased or reverse biased? A B
A sample of wire (1 mm in diameter by 1 m in diameter) length) of an aluminum alloy (containing 1.2% Mn) is placed in an electrical circuit, as shown in the figure next to. A voltage drop of 432 mV is measured at wire length when it carries a 10 A current. Calculate the conductivity of this alloy.
a sample copper wire has a resistance of 50 ohms at 10°C . what is the maximum operating temperature if the resistance of the wire is to increase by at most 10 percent? a at 10°C is 0.00409 per °C
Part c
Compare alternative and direct currents by comparing their physical properties. (Explain alternans, cycles, periods, frequency terms during this comparison. Also in this comparison, explain the electron flow directions separately in alternating and direct current)

SEE MORE QUESTIONS

Recommended textbooks for you

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning