Q.2) In a drained triaxial test carried out on a specimen of clean dry sand failure occurred when the total vertical stress was 423 kPa and lateral stress was 138 kPa. Find: The value of o' of the sand, The normal and shear stress acting on the plane where failure is about to occur, a)

Q.2) In a drained triaxial test carried out on a specimen of clean dry sand failure occurred when the total vertical stress was 423 kPa and lateral stress was 138 kPa. Find: The value of o' of the sand, The normal and shear stress acting on the plane where failure is about to occur, a)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In a triaxial tests carried out on a sand sample with cell pressure 20 kPa, the observed value of applied stress at the point of failure is 4 kPa. The angle of internal friction on the soil is? mmmmm
Assume that both a triaxial shear test and a direct shear test are to be performed on a sample of dry sand. When the triaxial shear test is performed, the specimen fails when the major and minor principal stresses are 80 and 20 lbs/in^2, respectively. When the direct shear test is performed, what shear strength can be expected if the normal stress is 4000 lbs/ft^2? Show all work.
Soil
The results below were obtained at failure in a series of consolidated-untrained triaxial tests, with pore water pressure measurement, on specimens of a fully saturated clay. Determine the values of the shear strength parameters c' and 'If a specimen of the same soil were consolidated under an all-round pressure of 300 kN/m² and the principal stress difference applied with the all-round pressure changed to 400kN/m², what would be the expected value of principal stress difference at failure" 150 300 450 600 03 (kN/m²) 01-03 (kN/m²) u (kN/m²) 103 202 305 410 82 169 252 331
2- A three-axis compression test on a clay sample that is comprehensive and normal up to a stress of 300 kPa and a specific volume of 2 Consolidated is done, The values of q and volumetric strain are measured at axial strain, 0, 2 and 10 percent (failure) . The value of N is equal to 3 and A is equal to 0.2. Graph of all-round stress on initial all-round stress Draw the initial all-round stress in terms of section
Calculate this one..,
In an Oedometer apparatus, a specimen of fully saturated clay has been consolidated under a vertical pressure of 50 kN/m2 and is presently at equilibrium. The effective stress and pore water pressure immediately on increasing the vertical stress to 150 kN/m2, respectively are...?
A soil specimen is subjected to a tri – axial test. The soil specimen is cohesionless. If the shear stress that causes failure is 300 kPa. and the normal stress at failure is only 500 kPa 5. Determine the angle of shearing resistance in degrees 6. Determine the angle that the failure plane measured from the major principal plane. 7. Determine the total axial stress in kPa at which failure is expected to occur.
Question-3: (a) In a consolidated drained triaxial test, a specimen of saturated sand failed under an deviator stress of 250 kN/m², when the cell pressure was 100 kN/m². i. Illustrate by drawing the Mohr circle for the failure stress condition. Solve for ø' and the theoretical inclination of the failure plane to the ii. horizontal. iii. failure. iv. Solve for the shear stress on the failure plane and maximum shear stress at Solve for factor of safety with respect to shear strength on the plane of maximum shear stress?
c. An undisturbed soil sample, 110 mm in diameter and 220 mm in height, was tested in a triaxial machine. The sample sheared under an additional axial load of 3.35 kN with a vertical deformation of 21 mm. The failure plane was inclined at 50° to the horizontal and the cell pressure was 300 kN/m². i. Draw the Mohr circle diagram representing the above stress conditions, and from it determine: - Coulomb's equation for the shear strength of the soil, in terms of total stress; - the magnitude and obliquity of the resultant stress on the failure plane. ii. A further undisturbed sample of the soil was tested in a shear box under the same drainage conditions as used for the previous test. If the area of the box was 3600 mm² and the normal load was 500 N, what would you expect the failure stress to have been?
In a tri-axial test of a silty soil, the sample failed at normal stress of 475 kPa and a shear stress of 350 kPa. 1. Which of the following gives the angle of internal friction. 2. Compute the angle that the failure plane makes with the x-axis 3. Compute the maximum failure stress
Soil Mechanism