Q.1 For the network of Fig.1: a. Find the current I b. Find the current I, using current divider rule c. Find the voltage V, d. Find the voltage Vs using voltage divider rule R5 + V - E - 24V- 1 R 6 kf 3.4 kl 12 kn Fig 1

Q.1 For the network of Fig.1: a. Find the current I b. Find the current I, using current divider rule c. Find the voltage V, d. Find the voltage Vs using voltage divider rule R5 + V - E - 24V- 1 R 6 kf 3.4 kl 12 kn Fig 1

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 47P: (a) Of what material is a wire made, if it is 25.0 m long with a diameter of 0.100 mm and has a...

See similar textbooks

Related questions

Q: battery is measured to have an open-terminal voltage of 14.2 V. When this voltage is connected to a…

Q: A cylindrical resistor of radius 3.0 mm and a length of 3.0 cm has a resistivity of 2.6 x 10-3 Ωm.…

Q: In the figure, R1 = 100. Q, R2 = 50. Q, 1 = 6.0 V, 52 = 5.0 V, and 3 = 4.0 V. a) Find the current in…

Q: Three resistors, R1= 30 Ω, R2= 77 Ω, and R3=R, are connected in parallel with a 12 V battery. A)…

Q: Given the equation, V =VneRC. RC what size of resisto required to drop the voltage on a 250µF…

Q: 75.0 N, %3D %3D 6.33 In Figure P.6.4, VB = 12.0 V, R1 = 100.0 N, R2 = 55.0 N, R3 .. R: Figure P.6.4.…

Q: Due to a weak connection, there is a break in the circuit (shown below) between points a and b. If…

Q: 10. Five resistors R₁ =7.00 2, R₂ =3.00 2, R3-13.0 2, R4=10.0 2, and R5=7.00 2 are mounted as shown…

Q: The resistors in the circuit below have the following values: R₁ = 6.80, R₂ = 7.00 , and R3 = 3.10 .…

A: Consider the figure as shown below.

Q: A. A wire made of silver has a radius of 1.2 mm and a length of 300 m. The resistivity of silver is…

A: A wire made of silver has a radius = 1.2 mm and length = 300 mSilver has a resistivity = 1.59e-08…

Q: In the diagram shown, assume the battery voltage is 10.0 V. All resistors are equal. a. Find the…

Q: 60 N 4. A circuit is shown with the currents below. ww a) Find the current through the 60 Q…

Q: You have a 100 meter long hollow square copper wire that has a side length of 5mm. The diameter of…

Question

For the network of Fig.1:
a. Find the current I
Q.1
b. Find the current I, using current divider rule
c. Find the voltage V,
d. Find the voltage Vs using voltage divider rule
R4
9 kl
Rs
9 kn
+ Vs-
E - 24V 4 R
R 3.4 k
6 kfl
12 kfl
Fig 1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) What is the resistance often 275-O resistors connected in series? (b) In parallel?
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
Using your understanding of the nature of internal energy and temperature, explain why we might expect the resistance of a solid to increase if its temperature increases.
Unreasonable Results (a) What current is needed to transmit 1.00 102 MW of power at 10.0kV? (b) Find the resistance of 1.00 km of wire that would cause a 0.0100% power loss. (c) What is the diameter of a 1.00-km-long copper wire having this resistance? (d) What is unreasonable about these results? (e) Which assumptions are unreasonable, or which premises are inconsistent?
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
A car battery with a 12-V emf and an internal resistance of 0.050 is being charged with a current of 60 A. Note that in this process the battery is being charged. (a) What is the potential difference across its terminals? (b) At what rate is thermal energy being dissipated in the battery? (c) At what rate is electric energy being converted to chemical energy? (d) What are the answers to (a) and (b) when the battery is used to supply 60 A to the starter motor?
What is the current in milliamperes produced by the solar cells of a pocket calculator through which 4.00 C of charge passes in 4.00 h?
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
Unreasonable Results (a) To what temperature must you raise a resistor made of constantan to double its resistance, assuming a constant temperature coefficient of resistivity? (b) To cut it in half? (c) What is unreasonable about these results? (d) Which assumptions are unreasonable, or which premises are inconsistent?
A student uses a 100.00-W, 115.00-V radiant heater to heat the student’s dorm room, dining the hours between sunset and sunrise, 6:00 p.m. to 7:00 a m. (a) What current does the heater operate at? (b) How many electrons move through the heater? (c) What is the resistance of the heater? (d) How much heat was added to the dorm room?