Q- The thermal and electrical efficiencies of a 100 MW steam station are respectively 30% and 92%. The coal used has a calorific value of 6400 Kcal/Kg. For the supply of full-load rated capacity the coal consumption in Kg/hour would be approximately

Q- The thermal and electrical efficiencies of a 100 MW steam station are respectively 30% and 92%. The coal used has a calorific value of 6400 Kcal/Kg. For the supply of full-load rated capacity the coal consumption in Kg/hour would be approximately

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What bio-energy fuel can be derived from vegetable oil? O a. methane O b. charcoal O C. syngas O d.…

A: Right Answer option (D) bio-Diesel

Q: A generating station burns 0.75kg of coal per kWh. The calorific value of coal is 6855kCal/kg.…

A: Let us find the overall efficiency of the station using the formula as provided below.

Q: Question 4 (a) Geothermal resources are hot water or steam reservoirs that can be tapped by drilling…

A: Part (a): The utilization of geothermal water/steam depends on the temperature of water resources.…

Q: Read the question carefully and match the answer with its respective question: It has been predicted…

A: given present load factor = 0.67 present year maximum demand = 6 MW load factor = average…

Q: 1. A pump driven by 240V motor lifts 1000 ft / min against a head of 50 m of water. The efficiency…

A: Given pump driven by motor Voltage v=240 vMotor lifts 1000 ft3/minHead h=50 mThe efficiency of the…

Q: Please i want the answer son as possible

A: Given that P = 10kw V = 18 m/sec Cp = 0.32 ngb= 0.9 ng= 0.92 r the Power In The Wind Equation: P =…

Q: B// Calculate the average load on a steam power station which spends (47x10°) IDQ (Iraqi Dinar) per…

A: According to question:

Q: 5 Classification of 10 MWe capacity solar power plant

A: Solar power plants can be classified in many different ways, depending on the criteria used. Here…

Q: What is the percentage of thermal efficiency of a fossil fuel power plant? If the percentage of…

A: Given, Electrical efficiency = 63.7 % Overall efficiency = 0.172 = 17.2 %

Q: In electric power systems, all the following parameters will be reduced after improvement of power…

A: To choose the correct answer

Q: Solve the problem below. When solving, use all possible decimal places. However, express your final…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: A 2 KW, 230volt electric heater is needed to raise the temperature of a 10 lbs water for 30 minutes.…

Q: The energy that "sloshes in and out" of a load without causing any net power transfer is called the…

A: Power:- Power can be defined as the amount of work completed in a given amount of time. Watt (W),…

Q: The below table shows all the combinations considered when solving a unit commitment problem…

A: The table given below shows all the possible combinations which involve operations of 3 thermal…

Q: Which units give the unit of electrical potential?

A: According to question:

Q: Which renewable energy source is not from the sun? O a. geothermal O b. wind O c. biomass O d. wave

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: 1. a) Write a short note on the generation of electrical energy. b) Define a steam power station and…

A: Generation of electrical energy - The transfer of energy found in many forms within the…

Q: An electric lift is required to raise a load of 5 tonnes through a height of 30 m. One quarter of…

Q: Medupi power station uses coal of calorific value of 5880 kcal/kg to generate electricity.They use…

A: Most of human energy requirement is meet by generating electrical energy. Once electrical energy is…

Q: Problem Statement: For a 50MW power plant, with a cycle efficiency of 44% do we lock in a long-term…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Referring to the Figure 2, compute the following values, given that the operating frequency is 60Hz…

A: Given that Voltage E= 120 V Frequency, f=60 Hz A circuit is shown below. Find inductive reactance,…

Q: a) List 5 types of alternative electric power systems. For each system, briefly describe the power…

A: (a) Low-carbon energy is energy produced with fewer carbon emissions, such as wind, solar, hydro, or…

Q: Select in descending order based on percentage the primary energy use of the world O a. petroleum,…

A: There various of energy source in the world . Coal Natural gas Petroleum

Q: A power generating station has a maximum demand of 1000 MW. The annual load demand of 1000 MW. The…

A: Maximum demand=1000 MW, Annual load demand=1000 MW, Annual load factor=75%, Plant capacity…

Q: Find the complex power supplied by the source and the power factor of the source for the network…

A: The solution can be achieved as follows.

Q: I need the full and correct expert solution for handwriting.

A: 1.To determine the maximum breakdown strength of air at 76 cm Hg pressure and 25°C, we first note…

Q: A string of suspension insulators consists of three units. The capacitance between each link pin and…

A: First we will derive the relation between voltage across the various units of the string.string…

Q: c) A power plant delivers 100 MW from 6 am to 2 pm and 150 MW from 8 pm to 12 am. The power plant…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A power plant produces 1000MW to supply a city 40km away. Current flows from the power plant on a…

A: The solution to part a is as follows, but the solution to part b can not be achieved as the…

Q: A wind turbine that is 80meters tall with a blade length of 160ft will be used to generate…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: Q2: A: A hydro-electric station is operated with a mean head (h) of 30 m and consume (discharge…

A: In hydro electric power plant, the potential energy of water is used to generate electricity. It is…

Q: B// Calculate the average load on a steam power station which spends (47x10°) IDQ (Iraqi Dinar) per…

A: Given: A steam power station spends (47x106) IDQ (Iraqi Dinar) per year for fuel used in the…

Q: A: A hydro-electric station is operated with a mean head (h) of 30 m and consume (discharge water)…

A: Given,Mean head, h=30 mDischarge water, Q=218.75×106 m3/yearLoad factor =80%Mechanical efficiency =…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Q- The thermal and electrical efficiencies of a 100 MW steam station are respectively 30% and 92%.
The coal used has a calorific value of 6400 Kcal/Kg. For the supply of full-load rated capacity the coal
consumption in Kg/hour would be approximately

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

It is the ratio of the units of electricity generated per year to the capacity of the plant installed in the station ratio of the duration during which the plant is in actual service to the total duration of the period of time considered ratio of the average load to the peak load during a certain prescribed period ratio of the average load on a machine or equipment to the rating of the machine or equipment, for a certain period of time considered Ratio of maximum demand of the plant to the rated capacity of the plant
A.) A coal-powered station has a maximum demand of 30 MW, a load factor of 60%, plant capacity factor of 48% and plant use factor of 80%. What is the daily energy produced in MWhr? Round your answer to 2 decimal places.
Problem Solving: Solve the problem below. Use all available decimal places in solving. Please refer to the specified decimal places for the final answers. A power station supplies the following loads to the consumer. The rated load is greater than the peak load by 15 MW. Time (hrs) 0-5 Load (MW) 15 5-8 20 Determine the following: 8-11 11-13 13-15 30 45 a. Total Energy Generated in MWh (use whole number) b. Average Load in MW (use two decimal places) c. Load Factor (use two decimal places) d. Capacity Factor (use two decimal places) e. Use Factor (use two decimal places) 75 15-16 50 16-19 40 19-21 21-24 35 25
Part 4 please.
A noninductive heater element with a resistance of 5 2 is connected across a 60 Hz source. The supply has a sine wave voltage with an instantaneous maximum value of 141.4 V. a. Determine the power in watts taken by the heater unit. b. What is the energy, in kilowatt-hours, taken by the heater unit in one month if it is operated 5 hours per day for a period of 20 days?
Q1: Answer only one of the following: A- What are the advantages of a diesel power station? B- Several points should be taken into account in the selection of the site for the Nuclear power station. State these points.
Consider a wind turbine that has a blade length of 21 m. The efficiency of the wind turbine system is 36% and air density is 1.2 kg/m³. What is the sweep area (in m²)? m² Calculate the electricity generated (in kW) at the following wind speeds by the wind turbine. for wind speed = 8 m/s KW for wind speed = 10 m/s KW for wind speed = 12 m/s KW for wind speed = 14 m/s kW
Below is the power curve of hydroelectric, wind and coal-fired power plants and all three data on the economy of the power plant are given.a) Calculate the unit energy costs for coal, wind and hydroelectricity.b) Calculate the average energy cost for all three power plants.
A power station of 4 MW has an overall efficiency of 0.35 and a fuel calorific value of 7500 k.calorific /kg. If the loaf factor and plant capacity factor of the station is 0.8 and 0.7 respectively. The fuel cosumprtion in kg for one hour at maximum load. * 17649 23544 O 11467 non of them 29750
14. For a power plant with two units, the weekly load is 1200 MW. The coal consumption (tons/hour) for each unit is Q₁ 16+.3P₁ tons/hours Q2-25+.4P₂ tons/h The total coal available to the plant is limited to 90,000 tons/week. If the linear cost curves are given as C₁=495+11P₁ $/hour, C₂-760+10P₂ $/hour And generation by each unit is limited to 150 ≤ P, ≤ 600MW Determine the values of P₁ and P₂ for minimizing the cost of power generation. 15. Use LP to determine economic dispatch if C₁ = 5+ 3P₁, C₂ = 7+6P2, C3 = 8 + 9P3 50 P₁ < 150 MW and PD=210 MW If the line flow P12= .3P₁ + .4P₂ + .1P3, also determine P₁, P₂ and P3 so that P₁2 is limited to 70 MW. 1 4 400 ≤ P₂ ≤1000MW H 2 3
...
Assume that Spinning reserve is not available for the power generation scenario of a country. What will be its impact in the power system? [Answer should not exceed three sentences] A BI