Q-9) The current source the circuit shown in Figure below supplies 131.16-j36.048 VA and the voltage source supplies 64.2275-87.8481VA. Determine the values of the impedances Z1 and 22. 2/15° A 100Z-30° V Z₁ + Z₂ 2 N

Q-9) The current source the circuit shown in Figure below supplies 131.16-j36.048 VA and the voltage source supplies 64.2275-87.8481VA. Determine the values of the impedances Z1 and 22. 2/15° A 100Z-30° V Z₁ + Z₂ 2 N

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: 2) A sinusoidal alteznating voltage has Eo Mo S. value of 200V and 50 H7. It cEOSses an a fzequency…

A: Given : f=50 HzVrms=200 V The angular frequency can be calculated as : ω=2πfω=2π×50 Hzω=314 rad/sec…

Q: The output voltage waveform of a four quadrant chopper is shown in figure. In the waveform, Vdc is…

A: First write the expression for given output voltage waveform and than evaluate the rms value of the…

Q: Ac - 100 Vrms R1 - 1k R2 - 500 Rload - 1k Capacitor - 2uF Q1. How much is the capacitor voltage…

A: To determine the phase lag between the capacitor voltage and the AC source voltage, we need to…

Q: A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle…

A: In the question, Find the source voltage if output current waveform is given. Duty cycle=50%…

Q: An impedance load consisting of 12 ohms resistance and 16 ohms inductance reactance is connected…

Q: For a series RLC circuit with a sinusoidal input voltage, the amplitude of the current passing…

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Square voltage wave

Q: What is the value of capacitance if the capacitive reactance is 50 Q .Assume frequency of supply as…

A: In this question we will find capacitance..

Q: Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an…

A: The given circuit isWe need to find The formula for the total impedance, Ztot.The formula for the…

Q: Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in…

A: Given two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in…

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Given oscilloscope peak to peak voltage is 10Vp-p at certain frequency. Hence maximum voltage Vm=5V…

Q: Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of…

A: The required parameter can be obtained by calculating the impedance of the capacitor and then by…

Q: 9. What will be the impedance of a LR-C circuit if it has a circuit current of 3A and a supply…

A: 9. Answer: 40 ohm Explanation: a. It is not a valid option, By using ohms law the resistance is the…

Q: Find the magnitude of the total current.

Q: Apply a sinusoidal input voltage with 2V p-p and vary the frequency according to the table below.…

Q: The source in the circuit shown is a sinusoidal source. The supply voltages across various elements…

A: Given a series RLC circuit, Voltages across each elements are as, Resistance voltage, VR=3 V…

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: 15. You are working on a power factor correction installation, and you notice with a clip-on ammeter…

Q: 12.6 Determine the phase relationship between the sinusoidal waveforms of the following set: v(t) =…

A: Note: As you have mentioned for a handwritten solution, I am solving it in both formats handwritten…

Q: A certain impedance is given by 1012° N. Does the current lead or lag the voltage, and by how many…

A: Impedance

Q: please write the complete solution and the topic is AC parallel circuits thank you A sinusoidal 50…

Q: shown in the Vps low is Write the FORMULA for the total impedance of the circuit Zut= R²+ cL- Write…

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of…

A: The circuit diagram is: V1 contains harmonics and the amplitude of the harmonics is inversely…

Q: Show that the following property of the twiddle factor is valid: WNk+N=WNk

A: In Discrete Fourier Transform (DFT) terminology, the twiddle factor is defined by the following…

Q: 07. Tice capacitors, a 12 µF, a 20 µF, and a 30 µF. are connected in series to a 60-Hz source. What…

A: In this question we will find reactance of series disconnected capacitors...

Q: What impedance vector (0- j15) Ohms represents: A. A pure resistance. C. A pure capacitance.…

A: Since real part is 0, so it can't be resistor. So option A is wrong.

Q: An inductive impedance and a resistance is connected in series with a 220V ac source. The power…

A: Given that VS=220V PF=0.94 Fig: R-L circuit It the RL series circuit magnitude of source…

Q: Ererises IA platinum oil has a resofance of 3.14k r at go°C and 3.747 JV at 100°C. Find the…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in…

A: When the same current flows through all the elements, they are said to be in series. When the same…

Q: QUESTION 4 A resistor, a capacitor, and an inductor are connected in series with a function…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: To Clip the input voltage at a fixed upper and lower level, a Clipper circuit is used. The Clipper…

Q: draw the thevenin equilvalent circuit and determine the load impedance for maximum power transfer.…

Q: Consider a drcuk where an ideal Inductor Ln.144H is connedted in parallel to a resistor R1.00k. This…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: inductive impedance made up of a resistor and an inductor has the characteristic that its current…

A: In this question , we will write current and voltage lag lead relation in inductive circuit...

Q: QUESTION 5 A resistor, a capacitor, an inductor, and a mystery component are connected in parallel.…

Question

Q-9) The current source the circuit shown in Figure below supplies 131.16-j36.048 VA
and the voltage source supplies 64.2275-87.8481VA. Determine the values of the impedances
Z1 and 22.
2/15° A (1
100Z-30° V
Z₁
1
22

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: Solution

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A certain impedance is given by 1012° N. Does the current lead or lag the voltage, and by how many degrees? Fill in the blanks. The current the voltage by
Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).
For the circuit diagram in figure Q22: which of the following is the total impedance? 12 Ri 10R R2||5R Figure Q22 V 220V40 50HZ L1 315mH C1=350uF O a. 3.33/0° O b. 4.71290°2 O c. 7.3304-19.66° O d. 10.37261.19°2
Circuit theory
Show solutions.
....tr
box the final answer.
Ac - 100 VrmsR1 - 1kR2 - 500Rload - 1kCapacitor - 2uF Q1. How much is the capacitor voltage lagging from the AC source
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
6 to 8
For a series RLC circuit with a sinusoidal input voltage, the amplitude of the current passing through the circuit (I, in mA) is plotted as a function of frequency for two cases: Curve 1 with R1, L1. and Curve 2 with R2. L2 as shown in the next figure. The value of the capacitor used in the circuits is C=0.01 micro Farads. If the value of R2 =1600 Ohm then the input voltage (in volts) is: 7.5 25 110 Frequency H2 O a. 4 O b. 16 sin(9888 t) O c. 8 O d. 8 cos(6.28 f t) O e. 8 sin (6.28 R t)
Ererrises: IA platinum oil has a resifance of 3-14k r at go°C and 3.747JV at 100°C.- Fin'd the resistance at o'C ond the kmp -creff. of resifonce af 40°C 2. A pofential difference of r5oV is apphed to a field wnding at 15°C and the currend is SA. What will be the mean fempouafure of the winiding when currend has falen to 3.91A, apphedvrltage being constant Aasume s =p7.5. 3. A cril has a resi fance of 182 when its mean femperature is 20°C and 20v when ik mean femperature s 50°C. Frid is mean femperature rise when ik resotonce is 21JL and the sorrandinig femperature is i5°C. A cril of a relay takes a curre of 0.12 A when it is at the vem insbi o al 4. A jemperature of is'C ond canneckerdacms a oV supply If the minimum operating current of the relay is 0.1 A, colculate the femperature above ohich the relay will fail to operate when connected ti the same supply. Resi tncenfemp.coefficrenf of the cril makria] is o.0043 per °C at 0°C.