Put a diagram on it pls. Thank you! We would like to distill a diluted mixture having 20% mole alcohol into two ethyl alcohol-water mixes, each of which will have 90% and 50% alcohol by mole. About 2% of the ethyl alcohol in the feed may end up in the bottoms since 98% of it must be recovered in these two products. Calculate the amount of every stream if the bottoms contain 0.6% alcohol

Q: strawberries contain about 15% wt solids and 85% wt water. to make strawberry jam, crushed…

A: Given that  Strawberries contain   15% wt solids 85% wt water 1 kg Jam  which contain one-third…

Q: An evaporator is fed with a solution containing 10% sodium hydroxide, 10% sodium chloride and rest…

A:

Q: A) What factors might lead to failure of the reactor and/or rupture disk?  B) Associate each factor…

A: Silane SiH4 analogues to methane with silicon. This is used in decomposition of silicon with…

Q: A solution is prepared by mixing 5.00 mL of 0.00100M iodine, 10 mL of 0.500M HCl, and 10 mL of 2.00M…

A: A Solution containing 5.00 mL of 0.0010 M  iodine      10ml of .005 HCl     10 mol of  2.00 M…

Q: Typical data on the ultimate analysis of the combustible components in residential MSW Percent by…

A:

Q: Carbon dioxide is added at a rate of 10 kg/h to an air stream and the air is sampled at a sufficient…

A:

Q: 1. A 100 kg of 20% aqueous solution of was fed in a diluting stream of pure water to produce a 8%…

A:

Q: It is proposed to separate CaCO3 (solid) from slurry via crystallization. The feed slurry contains…

A: Given data: Concentration of dilute solution = 5 wt % NaOH Amount of feed slurry = 100 kg

Q: a water solution containing 10% acetic acid is added to a water solution containing 30% acetic acid…

A: Given Water solution,1(10% acetic acid)+ Water solution,2(30% acetic acid)→Product Flow rate water…

Q: 100. mol/hr of a mixture of hexane (60.0 % by mol) and acetone are fed into a flash drum and…

A: The objective of the question is to determine the total flow rates of both streams exiting the flash…

Q: Acetone is used in the manufacture of many chemicals and also as a solvent. In its latter role, many…

A: Apply material balance on overall process including all the 3 units (adsorber column, distillation…

Q: Calculate the % yield for each crude solid based on the total amount of starting mixture. Starting…

A: Given: The mass of the starting mixture is given as m = 0.804 g, The mass of crude…

Q: mixing process

A:

Q: Sunflower oil contains 0.090 mol palmitic acid (C₁6H320₂)/mol, 0.060 mol stearic acid…

A: Given that, The molar flow rate of sunflower oil n2 = 305 molh Composition of sunflower oil Palmitic…

Q: You are given a 1.25 gram mixture of calcium nitrate and calcium chloride. You dissolve this mixture…

A: Given, Mass of calcium nitrate +calcium chloride mixture = 1.25 g Volume = 200 mL = 0.200 L…

Q: 6) Flash Distillation Model... Suppose we decide to distill the same 1000 moles of the 82 mole%…

A: Given data: Flow rate of feed = 88.3 mol/h Flow rate of bottom product = 11 mol/h Composition of…