pump with an impeller diameter of 0.02 m, an impeller speed of 58.3 rpm, a * total capacity of 12 L/s, an available head of 70 m, and a brake power of 12 kW is used to pump water. Determine the capacity of a homologous pump with twice the impeller diameter and operating at half the speed. Choices: A.60L/S B.36 L/S C.48 L/

Q: Question Two ( A three stage C.P. has impellers (Pcm) in diameter and (1.8cm) wide at outlet. The…

A: A three stage C.P. No of stage = 3 Diameter of outlet D2= 40 cm =0.4 m Width pof outlet B2 = 0.018m…

Q: The manufacture has identified the displacement of this pump as 1.25 cubic inches per ev. The prime…

A:

Q: For a given centrifugal pump, if the speed of rotation of the impeller is cut in half, how does the…

A: Given data: N2=N12 Need to determine the total head capability change.

Q: Shown in the Figure is the complete pump performance chart for a  3×4-10 centrifugal pump at 1750…

A: Given   Total head, H = 50 ft = 15.24 m         Speed, N = 1750 rpm   Flow rate, Q = 200 gal/min =…

Q: 2/3 Summarize the rotor theory of centrifugal pumps, focusing on the following topics: Action of…

A: A centrifugal pump is a mechanical device designed to move a fluid by means of the transfer of…

Q: ttempt only if you are 100% sure, The wrong answer will be reported. [1]How long would it take a…

A: The diameter of cylinder is The stroke length is The volume rate is

Q: For numbers 33 to 35, A pump with an impeller diameter of 0.02 m, a speed of 58.3 rpm, a total…

A:

Q: Describe a reciprocating pump's slip. Explain the differences between a reciprocating and a…

A: The reciprocating pump's slip and the differences between a reciprocating and a centrifugal pump.

Q: determine the rotation rate for the smaller , homologus pump . Using ONLY AFFINITY LAWS

A: To calculate the rotation rate of the smaller pumpgiven flow rategiven head of the pumpspeed of the…

Q: A cylinder with a bore of 4.5 inches and a rod diameter of 1.5 inches is to be used in a system…

A:

Q: A gear pump has a 75-mm outside diameter, a 55-mm inside diameter, and a 30-mm width. If the actual…

A:

Q: Question Four ( A pipe of (300 mm) diameter conveying (0.25m³/s) of water has a bend as shown in a…

A: Given: Diameter of the pipe: →D=300 mm=0.3 m So the cross sectional area →A=π4×D2=π4×0.32=0.07 m2…

Q: Explain Reciprocating pump? List the components of a reciprocating pump and briefly describe each…

A: We will discuss about the reciprocating pumps .

Q: Use the pump map attached, Suppose I want to pump water at 120 gpm against a head of 10 m. a. What…

A:

Q: For Questions 3 to 5 A certain centrifugal pump was tested and its performance curves can be…

A: To find: The efficiency of the pump. Given: The head is H=340-1.2Q2 ft. The Break power is…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.