Program Counter: 45 Accumulator: 123 Memory Location: Memory Address Content 45 STO 79 46 SUB 80 : : 79 737 80 012 : : Perform instruction 45. Perform instruction 46.

Q: The seven stages of the instruction cycle are shown in the following table. Put each stage in the…

A: 1. the PC (program counter) contains the address of the next instruction to be fetched.2. the…

Q: What happens to the values of the registers at each step when the program in memory is run on the…

A: It is defined as a type of computer memory used to quickly accept, store, and transfer data and…

Q: If r0 = 0x20000000 and r1 = 0xC3B2A, after STR r1, [r0], #4 instruction is executed, which of the…

A: If r0 = 0x20000000 and r1 = 0xC3B2A, after STR r1, [r0], #4 instruction is executed the following is…

Q: Suppose that the following instructions are found at the given locations in memory: 20 LDA 50 21 BRP…

A:

Q: A subtraction instruction takes two operands, subtracts the first from the second, and the result…

A: Instruction is a command which contains two parts OPCODE and OPERAND. where OPCODE is the machine…

Q: 1) into the data memory at address stored in ($s0). Hint: In this problem, the third byte value in…

A: Note: We are given the data in bytes so de defined the variable size by bytes "db"

Q: 1. Suppose the Pep/9 system contains the following four hexadecimal values: register A: register X:…

A: Hello student Answer will be in next step :-

Q: 333: E8B3 8B3: 0A12 A12: 2153 Since the contents of the relevant addresses are 333 in the…

A: According to the information given:-We have to define the contents of the relevant addresses are 333…

Q: Suppose the address of the first instruction is COAF3410 in hexadecimal in the following code. Show…

A: Here are the solutions.

Q: Assume that the instruction pointer, EIP, contains 9810 and the assembly language representation of…

A: Introduction: The Instruction Pointer Register, or EIP, communicates the address of the instruction…

Q: Data operation stage is happening after the operand address calculation in the instruction cycle.…

A: Instruction Cycle will, fetch stage, decode stage, execute stage.

Q: construct the program for our imaginary computer!   There must be made of at least 5 instructions…

A: Assembly language which refers to the  a low-level programming language that are used for a computer…

Q: 16. If the first instruction "LXI H, 1100H" is positioned at address 7000H in memory, at what…

A: Correct answer of above given question is Option(1) 7003H i.e next instruction is located at address…

Q: 48. Write an instruction sequence that, when executed, rotates left through carry by one bit…

A: Instruction Sequence: These are the steps that are provided in a program to execute a task…

Q: For the memory locations in the table below, write MIPS code to add all the ele- ments, placing the…

A: Introduction MIPS (Microprocessor without Interlocked Pipeline Stages) is a reduced instruction set…

Q: 3. Suppose M8=x and M9=y. After each instruction has been executed, what is the content of the…

A: Suppose M8-X And M9=Y. After Each Instruction Has Been Executed:

Computer Fundamentals

The computer is termed computation. For calculating or computing something the device that has been used is known as the computer. Or we can say that for performing a fast arithmetic operation the device that has been used is a computer. Storing, processing, and retrieving are the main features of a computer.