Procedure 3: Permanganate and Sulfite lonsThe following experiment was carried out. Results of the experiment are shown in the picturebelow.1. Three small test tubes were obtained. 10 drops of 0.01 M KMN04 were added into eachtest tube.2. 1 drop of 6 M HCI was added to test tube #1 and 1 drop of 6 M NaOH was added to testtube #3.3. 10 to 12 drops of 0.1 M Na2SO3 was added to each of the three test tubes.2 32 3Figure 1. The picture on the left shows the three test tubes after step 2. The picture onthe right shows the test tubes after the addition of Na2SO3 in step 3.Record your observations, paying close attention to color, and presence of gases. There wereno odors detected for any of the test tubes. Any gases that would be observed would look likesmoke coming off of the solution. Write balanced net ionic equations forthe three reactions in the procedure, anddescribe the effect of pH on the degree ofoxidation that took place in the procedure?

Balance net ionic equation for the three reaction in the procedure

Procedure 3: The following experiment was carried out. Results of the experiment are shown in the picture below. 1. Three small test tubes were obtained. 10 drops of 0.01 M KMNO4 were added into each test tube. 2. 1 drop of 6 M HCI was added to test tube #1 and 1 drop of 6 M NaOH was added to test tube #3. 3. 10 to 12 drops of 0.1 M Na2SO3 was added to each of the three test tubes. 2 3 1. 2 3 Figure 1. The picture on the left shows the three test tubes after step the right shows the test tubes after the addition of Na2SO3 in step 3. The picture on Record your observations, paying close attention to color, and presence of gases. There were no odors detected for any of the test tubes. Any gases that would be observed would look like smoke coming off of the solution.

Procedure 3: The following experiment was carried out. Results of the experiment are shown in the picture below. 1. Three small test tubes were obtained. 10 drops of 0.01 M KMNO4 were added into each test tube. 2. 1 drop of 6 M HCI was added to test tube #1 and 1 drop of 6 M NaOH was added to test tube #3. 3. 10 to 12 drops of 0.1 M Na2SO3 was added to each of the three test tubes. 2 3 1. 2 3 Figure 1. The picture on the left shows the three test tubes after step the right shows the test tubes after the addition of Na2SO3 in step 3. The picture on Record your observations, paying close attention to color, and presence of gases. There were no odors detected for any of the test tubes. Any gases that would be observed would look like smoke coming off of the solution.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

In Part A of this experiment, you will be standardizing a solution of sodium hydroxide (NaOH) against a sample of oxalic acid dihydrate (H2C2O4⋅2H2O, 126 g/mol). Calculate the number of grams of H2C2O4⋅2H2O required to completely neutralize 25.0 mL of 0.120M NaOH.
The titration below was performed by placing 10.00 mL solution in an Erlenmeyer flask and titrating it with 0.1000 M HCl. What is the concentration of the solution being titrated? 0.02500 M 0.0500 M 0.0750 M 0.100 M 0.200 M
If it takes 22.42 mL of NaOH to titrate 25.00 mL of 0.100 M HCl solution in the reaction you are doing today,what is the molarity of the sodium hydroxide solution?
O Microsoft O shift V A chemistry student weighs out 0.0608 g of formic acid (HCHO₂) into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.1400M NaOH solution. OCHEMICAL REACTIONS Determining the volume of base needed to titrate a given mass... Calculate the volume of NaOH solution the student will need to add to reach the equivalence point. Be sure your answer has the correct number of significant digits. W Microsoft Microsoft 6.52.210... tab esc caps lock mL control Explanation ! 1 (8) Q A Check N © 2 W S #3 X T option command E x10 X D NOV 14 $ 4 C R S F do L % 5 V T G tv ♫ 6 MacBook Pro 9 Y & 7 H Ⓒ2022 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center | Accessibility U 8 1 9 BN M A O J K O O JOD 05 L H W P > { I command option DOCX + 11 ? | 1 9 OC
Please don't provide handwritten solution
Which answer choice
Classify each reaction as precipitation, acid-base, or no reaction. If the reaction is a precipitation, record either the Ksp or solubility of the product to determine if a precipitate is likely to be seen. Use a reference to see if the product formed may be colored or have an odor. If no reaction happens, write NR in the classification line. Thank you!
MISSED THIS? Watch IWE: Acid-Base Titration; Read Section 5.7. You can click on the Review link to access the section in your e Text. A 17.00 mL sample of an unknown HClO4 solution requires titration with 17.32 mL of 0.1000 M NaOH to reach the equivalence point. Part A What is the concentration of the unknown HC1O4 solution? The neutralization reaction is HClO4 (aq) + NaOH(aq) → H₂O(1) + NaClO4 (aq) Express the molarity to four significant figures. ► View Available Hint(s) M(HCIO4) = Submit Provide Feedback VE ΑΣΦ VO www ? M Next >
1. Reaction Add 1 drops of … Add 1 drops of… Did a precipitate form? 1 Fe(NO3)3 Na3PO4 2 AgNO3 3 Zn(NO3)2 4 Al(NO3)3 5 Pb(NO3)2