Problem IV. Using El is constant. E=200GPa and I = 1850x10^6 mm^4. a.) Determine the vertical deflection (in mm) of point A on the frame shown. b.) Determine the slope (in radians) of point A 4m 16 KN 10 kN/m 10 m 8m C 2 m D

Q: Define the term Shop Drawings?

A: A shop drawing is a drawing required by a construction contract to be submitted by the contractor to…

Q: 5. Suggest a tool to be used when installing formwork for a thick wall to hold the two sides of the…

A: In building, formwork refers to using support structures as well as castings to produce structures…

Q: A drawing environment in which menus, toolbars, and palets, and ribbon panels are displayed for a…

A: A drawing environment in which menus, toolbars, and pallet, and ribbon panels are displayed for a…

Q: When does the misuse of drawings occur?

A: # Usually As-built drawings are made by the contractor. These seem more like interpolations…

Q: NORTH 28 -12- 2 -17'-5" 7'9" l'-8" 9'-8" 15'-5" 4* - 3 EAST 24 2 5'-5" 24'- 2'4" 2'-1" 12-5" T 28'…

A: Solution I have done three questions for you  The solution of the above question is following

Q: research the following construction drawing and provide examples: 5. sectional drawings

A: Right hand side is the sectional drawing of the given PLAN

Q: If you are using the standard dimension style (not annotative) and want the text on paper space to…

A:

Q: Find the correct front view for the drawing given below.

A: i drawn a rough sketch of ront view   see it in below step

Q: Identify the various materials used for drawing

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.